Recent content by jhsiders

Nice! I'll try that. And, yes, I've got the case off and it's not spinning. Thanks for the help!

Thanks, I appreciate your help! I basically used the CLOVER folder I found here, including the iMac18,3 definition--for some reason, mine doesn't like 19,1. I was able to do the update, and everything is humming smoothly. One last thing, while I have you (if you don't mind): My case has a...

Ok, I’m back up and running after tweaking some BIOS info. I didn’t add any of this to config.plist and I’m up and running. Would you still suggest it? Mine is June 6, 2020

Ok, good to know. Updating the BIOS got me past the prohibited but it hangs now. I’ve attached a screenshot—is this the type of problem you mean? I’ll check on that when I get booted.

Ah, ok. I’m running F5, so I’ll update that right away and let you know if it helps. And thanks for the tip on the SMBIOS—I’ll update that as soon as I can. I was reading somewhere the prohibited sign could be due to NVRAM issues. After the prohibited sign, there’s a prompt to hit any key, and...

Thank you. My issue is that I can’t boot at all, even with USB. I’m using 18,2 and Clover 5119 as well.

I should note that I can’t even boot with my Catalina Unibeast USB. Curious.

I downloaded the combo updated to go from 10.15.5 to 10.15.7, and my Mac would boot right back to 10.15.5. When I tried booting to the Install [drive] - data loader, I got a prohibited sign. I read that changing Clover Configurator to BootLastVolume would allow it to update, but not there’s a...

Can anyone point me or help me with fully enabling the onboard graphics for this board? I'm not even sure where to start--the 'About' page only shows 6 MB available for graphics.