Recent content by icallanan

Hi Feartech. Once I put back in NullCPUPowerManagement.kext it boots as far as the 2nd last image but still hangs there. If I add -x safe mode with NullCPUPowerManagement.kext it reboots back into clover - strange why it does this. Have you any other ideas? It is driving me mad now.

No luck it keeps going this far and reboots

Here you go

Hi Feartech. Made that change and it booted further on and is hanging at this point now. Any ideas?

On it thanks

Yeah I am I am using the config_HD3000_1366x768.plist renamed to config.plist or have I missed something?

Hi Feartech. So I did as you said and goto. lot further into the boot process. However it has been stuck on the attached error for over 40 minutes now. But it is getting there. Any ideas what this could be or how to resolve it?

Cool I am trying that now will get back to you no doubt

Are you suggesting that I use Unibeast now? With USBInjectAll.kext to clover/kexts/other and use the laptop config.plist?

Yes I did

Sorry I thought I had done that yesterday. Done now.

It’s a Fujitsu life book A512

Anymore advice?

Hi Feartech. So I followed all the steps and made the USB. It boots to clover I select -V Verbose mode and tell it to boot but it just goes to a blank screen and nothing is displayed. I obviously have something set incorrectly but can't figure out what it is.

Just noticed your Irish name very cool. Fear Éireannach anseo freisin. Ran into a problem already. Downloaded Clover and following the instructions. Using Clover_v2.4k_r4701.RM-4963 from the download from this site. For Clover legacy, run the Clover Installer package: - select the target of the...