You can always get a USB Wireless/BT. I haven't seen inside a Corsair one, but I bet if you disassemble it you'll find an m.2 Wifi/BT card, which can be replaced.
700€ for a Corsair One Pro is a decent price! I'd go for it.
By "Clover method" I mean no UniBeast or MultiBeast. Just the standard Clover bootloader, no messing about in the /Library/Extensions or anywhere else in the system. Just Clover and the correct drivers and patches in the EFI partition on the boot drive.
It's really easy to install. Just follow instructions step by step. Follow a clover install guide. Follow steps one by one. Sorry, can't be any more specific, because forum rules do not allow helping others.
Select Boot OS X Install from Install macOS High Sierra again like you did during the first phase of the installation process.
Open Terminal through Utilities at the Top Menu Bar once installer finishes loading.
Type the following into Terminal and press enter after each line is entered:
ls -1...
Do not use multibeast. Find AppleALC.kext from github and install it to your boot drives EFI/Clover/kexts/other folder. In Clover config you need to set these options:
Under ACPI
- rename HDAS to HDEF
Under Devices
- inject audio ID 11
- select Reset HDA
You should also get the latest...
GTX 1070 ITX installed and configured. Had to clear CMOS to get the GPU to boot BIOS, but that was the most difficult part. I used webdriver.sh to install an older WEB driver from 10.13.2 and set the nvda_drv=1 and the card is working perfectly now.
I also noticed that Bluetooth was working, so...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.