Recent content by HaroldKurtz

thanks, I restored a entire clover /EFI backup and later edit the boot section with my volume name but doesn't work. Later I edited the section with Disk UUID and make a nvram reset from clover and voila, it works, fine. Now starts automatically and boot without problem, thanks a all the people...

Hi all Now I can boot, but not automatically. If I edit the config.plist and put my volume name on string section, it doesn't boot. Before installing the Wi-Fi drivers I had it like this and it worked fine. I did sudo kextcache -i / with this result: Password: kext-dev-mode allowing invalid...

thanks for your replies. I've booted with a usb live ubuntu and I've found a copy of my config.plist from a few months later, I copied to a EFI partition and I've booted!!! When I booted I deleted StatusBarApp.app and did the command sudo kextcache -I / but the commands returns "not work to...

Sorry, I only pretended to be correct I didn't make any copies of the EFI partition or the config.plist, I was very naive ... I've deleted the two kexts and doesn't boot, it hangs at "PCI configuration begin" message. My boots args that works fine until yestarday are: -v dart=0 npci=0x2000...

Hi friends, months ago I mounted succesfully a hackintosh for my wife and it has worked perfectly until tonight. I wanted to install the drivers for a usb wifi and after installing it has not started anymore. Every time I try to boot it gets a different message., What do you recommend me to do...

Sorry, now I updated my profile with hardware information and I attached a photo. Thanks!!

Hi people!! I read the guides and I've installed El capitan on Asus P5KPL-AM SE but I only boot with usb created. I've installed clover Legacy 2.44 and Clover 2.4 but not boot. I have also tried the autogenerated configuration but I can not boot without the usb, if I put it in verbose the error...