Update, I successfully upgraded from Catalina to Big Sur
This is what I did:
Update clover to latest version v5.1 r5127
Update AppleALC, Lilu, VirtualSMC and WhateverGreen. The full list of kext is:
$ ls -1 /Volumes/EFI/EFI/CLOVER/kexts/Other
Dear Hackintosh Community,
After following other threads and searching around, I successfully got into the Big Sur installer and updated from Catalina to Big Sur. However after reboot, it shows:
After the last screen, it stays there for a few seconds and reboots.
This is what I did:
1) Yes, I am using MacPro 6,1 - anything else my second display doesn't work :(
2) Yes, after mounting, it's in /Volumes/EFI/EFI/CLOVER/kexts/Other/USBPorts.kext -- the config.plist I'm editing is /Volumes/EFI/EFI/CLOVER/config.plist which is the correct path
Mac-Pro.local ➜ ~ sudo...
You are right, I had to "Rebuild KextCache and Repair Permissions" for the injector to disappear, now it shows this:
The ports on the case still don't work and nothing shows up when I unplug/plug devices in :( - any ideas?
I am trying to follow this guide: https://www.tonymacx86.com/threads/the-new-beginners-guide-to-usb-port-configuration.286553
However after rebooting, it is showing I still have any old version of USBInjectAll
Mac-Pro.local ➜ ~ kextstat | grep -i usbinj
I've followed the instructions to the tee, before the reboot, I see this and all my USB ports work perfectly, I can plug/unplug to any physical port:
So I disable the Clover patch, I remove the USBInjectAll.kext, put USBPorts.kext instead of it. I reboot, and see this:
The USB2 ports are...
I had the same problem, I changed my SMBIOS product name from Imac18,2 to 17,1 and then all screens went blank. I experimented with it a bit until I changed to MacPro6,1 which fixed it :D - this is with an RX580
I had the same problem, I changed my SMBIOS product name from Imac18,2 to 17,1 and then all screens went blank. I experimented with it a bit until I changed to MacPro6,1 which fixed it :D - with an RX580