Recent content by gardnerphotos

Thank you, I feared it might need a fresh install, thankfully it was a new install anyway so won't take long to recreate

My audio was playing up so I restarted the system as that usually fixes it, however when it powered back up it got to the apple screen, a loading bar appeared at the bottom and got to about 5% then the computer shut down and rebooted and continued to do that in a loop. I have tried all sorts of...

I have just built the recommended Mini ITX system from the buyer's guide using the Gigabyte GAZ87N wifi motherboard, but sometimes when the system wakes from sleep the audio stops working until I restart the system. Any suggestions?

Hi Neil, firstly awesome mod! Secondly what tool are you using to cut the case? I know you used a table saw for the big cuts but what about for example cutting out the front IO? I have tried using a Dremel on my G5 and it struggled to get through the aluminium. Also when you put in the new front...

This is a very helpful guide, thank you, I am not planning on using the Firewire or audio so is there anything I should do differently? I have currently just got the USB wired up and plugged into another computer for testing and when I plug a hard drive into it I get the power LED lighting up on...

I am using a Gigabyte GA X79 UD3 with an i7 3930K, 32GB of Corsair Vengeance Pro RAM a GTX780, a 120GB Boot SSD and 3x120GB SSDs for programs in RAID 0. I am running 2 Dell U2413 monitors which are 1920x1200 and I think that is about it

I tried applying verbose mode and it was unsuccessful so I uninstalled verbose mode again, still have to type in npci=0x2000 every time it boots, not the end of the world for now until we can find a solution

there are no graphics options on 2011? At least not on my motherboard

The only bootflag I need now is npci=0x2000, what should I do to fix that or will applying 1080 fix it?

I have just repaired permissions and now I only need to use npci=0x2000

My display is 1920x1200 and I am using 2 of them, will that affect this?

Have now got it installed on single SSD, boots fine but have to use bootflags, it won't boot without the following: GraphicsEnabler=No npci=0x2000*darkwake=0 PCIRootUID=0

Have to use the bootflags GraphicsEnabler=No npci=0x2000*darkwake=0 PCIRootUID=0 Have tried changing settings in MultiBeast but still won't boot without them

anyone got any ideas!?

Have attempted to install OSX 10.8.4 a couple of times now, each time once I have finished multibeast and reboot the system without the flash drive I get the error Missing Operating System, even when I plug the flash drive back in I still get the same error and have to reinstall. I am using the...