Recent content by ezbreaks

Hi, i just installed on my new hackintosh build. My build is: Motherboard: Asrock Z97 Anniversary Processor: Intel Xeon E3 1231 v3 Graphics Card: GTX 760 Asus Direct CU II 8 GB Ram Kingston HyperX Savage 8GB(2x4GB) DDR3 1600mHz CL9 1.5 V XMP SSD: KINGSTON 120 GB Everything seems to work...

Hi, I installed Mavericks on my pc but the temperatures is very high. The whole system is 45 - 55 . Is this right ?

Hello, Is there any ISO image for DUAL BOOT from USB STICK ? I have Maverick and Windows 7. My specs are the following: Gigabyte- GA-Z87M-D3H 8GB RAM 1 TB HDD INTEL i5 - 4570 Haswell Graphics Card - GTX 760

Hello Minihack, Hope that you are fine! Thank you very much for your help! I've solved all my problems, Now my new MDD CASE is working with my new motherboard! All fine... it doesn't look so good like yours in the back of case but i like it! Thank you very much again for your help. My power...

Hi, So, i have to do this thing??? http://www.tonymacx86.com/powermac-g4/44066-powermac-g4-switch-mod.html I'm verry sorry that there the pictures doesn't work. Some photos are missing.

Hello Minihack. Hope that you are fine..... Tomorrow i will receive i will receive the motherboard processor and source. I will have this configuration. Gigabyte GA-Z87M-D3H Processor : Intel Haswell i5 - 4570 Memory: 8Gb Crucial (4x4) Power Source : nJoy 600 Watt Hdd : WD BLUE 1 TB And a...

Hello everyone , hello Minihack, Thank you for your help and sorry for my delay. I have a old multimeter (not digital) is analog , when i put the red cable on the wire number "2" and the black cable on the wire number "5" the number from the glass goes to "60%" and when i connected the black...

Hello Andy94 Thank you very much for your reply , i have a MDD G4 Case... I don't have a small board with a chip on it. The power switch (On / Off Button) have that cable with 10 pins on it. I can show you some photos with my cable circuit. And this is the front panel of the motherboard...

Hello Minihack, I hope that you are fine. The reason i reply to your thread is that i need your help if you don't mind. I have the MDD G4 Case and i want to convert it to a miniAtx motherboard. I have some problems with the power ON / OFF button switch wires. What i have to do to connect it...