Recent content by Exway8

Attached EFI folder would help a lot, I'm on the way with my first Ryzen config with B550 and 3700x, fingers crossed.

Okay I confirmed that second slot x16 (x4 mode) on Z77-DS3H is Gen2. And only first slot is Gen3. The last question is hardware or BIOS defines it ? ;)

There is only PEG option, and I already set it to Gen3. All other slots are empty, BTW. So 4 lanes should be there. I will ask Gigabyte to be sure how it works.

I removed graphic card from slot x16, leaving M.2 in x4 - nothing changed, put M.2 adapter in x16 and BOOM full speed. I believe this adapter only using x4, so my call is that BIOS is glitched on that 2nd slot and only option is to flash it with modded or different mb BIOS. :/

yea I know, I was referring to my specific motherboard Z77-DS3H, am I wrong ? Also I run a test on Win 10, writing speeds at 4k looks ok there, so I'm assuming this AmorphousDiskMark is unreliable (even on osx when you run test on exFAT). But the cap 1,5Gb/s is still there and I wonder where is...

Isn't the blue ports on this board PCI-e 3.0? And this 4k write at 30 mb/s isn't close to limits right ?

I need a little help here Mojave 10.14.4, Clover 4910 970 EVO 500GB PCI adapter in 2nd PCIe x4 slot (first is a graphic) Jeyi Coolswift Z77-DS3H modded bios (added NVMe dxe module for boot) Everything is fine, fast boot etc, but I don't get full speeds, looks like PCIx2, but most weird is 4K...

Can you please share your config.plist ? I'm struggling here to get that e2200 kext working :/

What about Mojave fresh install directly on 970 Pro without cloning disk?

which rev. of this board you have ? on 1.0 I have a problem with ethernet, only old L1c kext is working :/

Same problem here, 10.14.1 clean install on z77-ds3h, 670 gtx, hanging on boot after apfs lines.

Same issue here :/ Any solution ?

I'm searching and reading too, but i have the older board Z77-DS3H with 3770K and I found that ivy bridge supports NVMe, but can someone confirm that with an adapter ASUS HYPER M.2 X4 it will perform on max capacity ?

anyone?

10.12.2 everything runs smooth and fine, fast boot but i have problem with rebooting and shutting down. -v shows : sandboxVlolation launchd(1) System policy deny(1) nvram-set boot-gamma and stays on it for about a minute, tried clear nvram -c, what else can i do ?