Recent content by dreidel

I had the same problem. Fixed it by using the recent beta for AppleALC.kxt.

Okay, that did the trick! OCLP built the kernel cache, and now the wireless card is fully functioning. Am posting this while surfing wirelessly. Thanks!

Okay, after quite a bit of work with my EFI folder and my config.plist, I've managed to finally get a working boot of Sonoma, to the point that I can run the OCLP Rootpatch Configurator. However, each time I've run it, I get the following message: "- Starting Patch Process - Determining...

That’s great news. Will this also work with regular OpenCore?

I'm still holding out for macOS Kitten.......

Thanks for this - using those settings for my Coffee Lake i5 9600KF in Clover Configurator allowed me to finally install and boot r5125, after I had borked my system last week with 5123. Still, I'll be hesitant to install Big Sur on my system until the new versions of Unibeast and Multibeast...

I have no doubt that there may be future Hackintoshs based on ARM. And when the new bootloader comes out, may I suggest naming it ARMthony :)

I decided to upgrade my hackintosh using the newest version of the Western Digital SN750 1 TB NVME drive in my Gigabyte H370M-D3H board. It's in the correct slot for 4 x speeds, the other is a WD Blue 500 GB NVME drive in the other slot (my current boot drive). The problem is - though I can...

they need to go back to the cat themes: because I want them to finally release macOS Kitten :)

if I were using cardboard, I'd probably want to brush on a fibreglass resin on it to reinforce it - it's a trick used by some crafters and cosplay prop people. Then again, I wouldn't mind seeing a computer built inside a bread box!

Gotta admit, when it comes to configuration I'm not always the sharpest knife in the drawer, and it often takes me reading an article 10-15 times before it takes. However, this new guide only took me about six reads before everything began to make sense. So this afternoon, using a whole bunch...

Before you get into the Clover screen on boot up, press F11 to flush your NVRAM. Boot into your Catalina disc, then apply the Supplemental update. When you reboot, the install partition should show up on the screen.

Tried a number of times to install the supplemental, no soap. Rolled back to Clover 5107, updated the necessary kexts and then did the F11 NVRAM flush as suggested. The install disk popped up, did install, got an error message saying unable to bless boot partition; however when I booted back...

Okay, I've got it solved - all I had to do was to install WEG, Lilu and AppleALC into Library/Extensions using Kextbeast. HDMI now working properly! (As well as the audio)

I've now installed Catalina 10.15.1 on a spare drive to give it a test spin - and discovered that the HDMI port on the card isn't working. Screen goes black. I am getting output on one of the DVI ports so I can see the desktop on my second monitor. . I have applied the newest WEG, Lilu and...