I have more info on this. I need to start the computer twice. First time it doesn't see the Apollo. I have to shut down and unplug the mains and restart. Then it works. Seems to be the same pattern everytime. Any ideas ?
BIOS F21
MAC 10.15.7
UAD APOLLO 8XP
TB config seems correct. I attached a screenshot.
Port was working yesterday. Not today and I cold booted a few times. I left it alone , plugged everything out and booted again and it's working now.
Any ideas why that would be?
Hi
My thunderbolt ports have stopped working for some reason. Have you come across this? I checked on two different devices, different cables and both ports.
Disregard the booting issue . I booted from the USB, removed the kexts from plist etc and booting fine again.
Did I install the kexts incorrectly? Or the wrong ones? As I mentioned I put the family kext in efi/oc/kernels and
also dragged it into the plist.
I think I did something incorrectly. I added the family kext to kext folder in EFI/OC/KEXTS and also dragged it into Plist. Now when I boot , I get stuck at the Apple logo. How do I go about removing these kexts?
Thanks for that. I did try it and think I did it correctly but didn't seem to work. I used Hackintool and tried to install the 1080211family.kext but I kept getting an error. Not really sure if I was doing it correctly. When it asks where to install the default is L/E so I choose that.
I get an...
It's not showing up. I have it installed on the motherboard. I have the cards as follows.
Nothing in the first slot.In 2nd slot is the UAD card, followed by the Apogee Symphony 64 card in the short pci slot and then lastly is the TPlink. I have tried it in the other slots and doesn't seem to...
Thanks for that. It worked a charm. The system is working fairly smoothly now. Both UAD and Apogee pci cards are working, Ethernet is working. I haven't been able to test the thunderbolt yet as I am waiting on a thunderbolt 2 to 3 adapter.
I had 2 questions.
1.In relation to the wifi card. I...
Thanks for that. So to clarify. Will I just replace my EFI with this one? And if I need to configure it , use version oc config version 2.65?
So I don't need to continue with USB port configuration?
Many Thanks as always..
Will
Hi again.
I used EFI mount to mount the EFI. I assume that was ok rather than terminal as per the guide.
The usbinject all kext was already there but I replaced it. It was also enabled in. Plist. I did tick the xhci port limit though.
I opened Hackintool and proceeded as per the guide. I am...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.