Recent content by dbfeenix

Hello Some news of my build. I received all my parts, all assembled and installed osx El capitan. All went well until the installation of nvidia driver. I did my build following this thread https://www.tonymacx86.com/threads/el-capitan-on-ga-z170x-ud5-success.193293/ And i can't instal the...

I read good review on the Cryorig H7 but hard to find here. The CM Evo seems good , maybe a little more noisy. but a good alternative if i can't find the noctua.

Hello, Again i need help ,impossible to find the noctua nh-u12s or the 14s here, they are out of stock. (2 - 3 week delay ) Would you have an alternative to propose? Roughly the same price and quiet ? i"ve seen the dark rock 3 but seems a little big and not easy to instal ... I would like to...

Ok , thanks a lot for your advice!!!! I will go this way!

it's really complicated choice of RAM. I can't afford 64Go right now, my budget is at the maximum. I did some research on the forum and what i learn : -not recommended to buy 32Go and put another 32Go later ( question of paired RAM??) -I read that it was necessary to have 3200 ram speed for a...

Thanks for your advice DavidPye : For the use of USB 3.1 port to Thunderbolt i must look at that , i really want something easy and OOB. trs96 : I prefer to have a more powerfull PSU to enable to upgrade my setup (maybe a more powerfull graphic card in the futur ) And i've a lot of hdd and...

Hi Ulii Thanks for your replies . This configuration is a bit expensive , I would like to reduce the cost but this is not obvious because I want a stable and powerful configuration. the Mobo : I first thought take the Gigabyte GA-Z170X-UD3 interesting because less expensive and possessing...

Hello everyone. First post on the forum but i learn a lot from this forum. I already have a hakintosh I build up in 2011 and this one started aging. So I need to build a new hakintosh to run my Pro Tools system. I have a firewire interface but i plan to buy an HDX Pro Tools systeme so it...