Recent content by ckleea

I am not sure of your meaning. It looks like the other thread you post would have similar chipset that I have fro the E7240 http://forum.osxlatitude.com/index.php?/topic/5974-mavericks-1091-hm87-iris-5100-asus-ux301la/?p=32332

My model is System: Dell/E7240 CPU: i7-4600U + Lynx Point-LP Graphics: HD4400 + 1920x1080 with touch Will the output from syschk be more useful?

I have a dell E7240 with i7-4600U. I am unable to make the graphics card work. I try various methods but either I need to use -x to enter safe mode or moving out AppleIntelHD5000*.kext out for a normal boot. It is read as HD4400 with id of 8086:016 The screen is 1920x1080 with touch...

So far I made it works after taking VoodooHDA. Then I install Mutlibeast ACL882 with DSDT. Every hardware works

Try to have a simple installation of multibeast in that "upgrade 10.8.2" partition. It works in my case

I have been able to install 10.8.2. but wish to extract DSDT and install into /Extra. However, I encounter an error when compile. Look for help Name (_HID, "ABCDEFGH") Error message is 11273 _HID suffice must be all hex digits (GH) Help is appreciate to fix error and...

Supplement to this - now 1. upgrade to 10.7.4 with 64 bits kernel running 2. Touchpad and Trackpoint working now Only is the display not accelerated. For wireless, still searching for a good half size card.

I am pleased to tell you that my Dell Latitude E4310 is almost fully functional with OSX Lion. I am able to boot up and install most important software. Few not working 1. touchpad is not functional. PS/2 issue - not yet able to fix 2. Intel wireless card. Known issue and is not of big deal...

Dear all, Won't like to seek help to make the SL bootable. I use iBoot and retail SL to install into a partition. It boots if I use iBoot but not able to do so after applying multibeast. Kindly advise if I can move the boot image part of iBoot 3.3 into the harddisk to allow booting directly...

My installed image can only boot from iBoot image. If I use multibeast, it can't boot If I try to update to 10.6.5, 10.6.6, 10.6.8 from combo update, can't boot (even first boot from iBoot CD) I then make a 10.6.3 retail install, it boots via i?oot ?? but the mousepad not working. ?gain can't...

Would like to seek more advice in this forum. I have now been able to install a retail Snow Leopard into the harddisk and book with IBoot 3.3. However, after that I am unable to upgrade or using multibeast to further configure the system. Once I did so, there is error in the IOPCI Family...

Re: UniBeast with Dell Latitude E4310 - can't get installer GUI I have made an interesting progress. Now I am able to install a 10.6 Snow Leopard using iBoot 3.3 CD. GUI comes up with sound, wired ethernet and trackpoint. GUI is just very basic. I am not sure how to proceed as I tried...

I am also looking for a solution. I have various disto DVD to boot. All stop at some where. Mine is Latitude E4310 with screen resolution 1600x900. Harddisk set yo use IRRT. My previous attempt in my old Latitude D430 is successful for both snow leopard and lion. I follow the osxlatitude.com...