Recent content by burrows1980

  1. burrows1980

    Touchscreen not working - HP Envy TS m7

    Did you find a solution to this? I’m on BigSur and same problem. Although it doesn’t work in windows on dual boot (same ssd) HID touchscreen is greyed out in DeviceManager. Can only assume it’s something to do with my acpi’s loading in OpenCore??
  2. burrows1980

    [Guide] HP Envy Haswell series J/K/Q/N using Clover UEFI

    Hi Moyan, Is your touch screen working?
  3. burrows1980

    [Guide] HP Envy Haswell series J/K/Q/N using Clover UEFI

    Ive had a look though, you seem to have a lot of drivers installed that you probably don't need? Which guide did you follow to set OC up? I used Dortanias guide, and followed word for word, including post install. Sound took me for ever to figure out but realised it was an IRQ conflict and...
  4. burrows1980

    [Guide] HP Envy Haswell series J/K/Q/N using Clover UEFI

    Ill have a look later for you if no one else has replied by then, I’m no Rehabman, but used his guides and adapted for OC for my system. What laptop have you got? Sound issue will more than likely be an IRQ conflict and you’ll need to use SSDTTime in windows to make a SSDT-HPET.aml.
  5. burrows1980

    [Guide] HP Envy Haswell series J/K/Q/N using Clover UEFI

    I’m on BigSur (Opencore) as well, nearly everything is working apart from touch screen, Apple TV videos but that’s Common from what I’ve read. I did have sd card reader working in Catalina but it freezes in BigSur. Even got boot chime working and windows dual boot, same ssd. HP Envy 15 J series
  6. burrows1980

    << Solved >> Help Please! Opencore Catalina does not boot up without USB

    Ace I’ve exactly the same issue
  7. burrows1980

    Combo Update 10.6.8

    Hi, Carried on searching the forum and found the screen thats being displayed is a Kernal Panic: http://support.apple.com/kb/TS3742 Not too sure why its doing this yet.... Gaz
  8. burrows1980

    Combo Update 10.6.8

    Hi, Ive installed SL on my Dell XPS L502X, it boots fine by using iBoot and typing GraphicsEnabler=No, Ive been following the guide but when I get to the part of updating to 10.6.8 it goes wrong! I open MultiBeast ready to run, then mount and install Combo. When it gets to the end of the...
Back
Top