Recent content by brewmattster

I was able to get Clover 5126 working. Found a solution on Clovers forums. Basically, I reinstalled BS, but when it reboots, run the Preboot partition to finish the installation. After, you'll have to boot from Preboot rather than you main partition, but everything is working! A little...

Gorilla arm!

No problems with this update, still have to select the proper boot volume to install but I'm over that.

Solved! Got this from another thread. Boot to the clover screen, press F-11 to clear the NV-RAM, reboot and go to the desktop, run the installer again and reboot. At the Clover screen press F-3 if the -Data partition isn't showing. Worked for me!

As the title says, I've upgraded all my relevant kexts to their newest version. I've also tried installing with Clover 5107, 5108, and 5109 with no luck. All it does when I restart is go to the black installer screen, thinks for a minute, the reboots. No Installer visible on the Clover boot...

Everything went great. I didn't update L/WG from the previous 10.15.2 update, but everything runs smooth. Took about a glass and a half of wine :)

Created a new UniBeast disk, tested and works perfectly, thanks for the great work!

I have the same card, I had to boot into safe mode in order to get to the desktop.

Thanks so much! Could only boot into safe mode due to the black screen, downloaded the attached file, everything is swanky now!

The USB stick that you create with unibeast to install OS X.

I ended up using my rescue usb stick to complete the job.

I have a very similar build, just no TH. I'm running a Corsair H100, I have the rads plugged into the pump, and the pump plugged into the CPU header. Great temps, even overclocking to 4.6. I also just upgraded to the newest bios, f21, everything is running fine. On a side note, I've had this...

Yep, searched for Mavericks, found it in the Canadian App Store, now downloading.

Not available in Canada yet, I'll keep checking. :banghead:

Oh my, now this brings back memories!!! Thanks!