Recent content by Booya

You can not downgrade bios below F.20.

Check your router to make sure you don't have your wifi network set as a hidden network, try and flush out your DNS caches and delete and reconfig your wifi to see if it help.

1333 MHz is what come standard with probook, You can use 1600MHz but you will not get the full speed. I use 1600MHz cause I just happen to have extra memory laying around. According to HP tech support, the bios limit the speed back to 1333MHz if you use 1600MHz.

Most 4530s USB3 is on the left side, its the blue one. It should work fine with the right kexts.

My i3 2350M, 8GB 1600 memory get around 5200 32bit and 5800 64bit. A little lower running off of battery (around 50-100 pts lower) The 1600 memory speed help, with the 1333 speed was around what you getting.

I use Atheros AR5B195 with AR3011 bluetooth combo card. One thing I hate about this card is its only 2.4G and don't work with 5G band.

I have it connected to both lion 10.7.4 and ML 10.8. No I don't use the probook installer, I have my own set of kexts.

I'm using a magic mouse connected with my HP bluetooth without any problem. Don't have any problem pairing, all gestures working with no lag and no disconnect problem. Don't have any problem with my magic track pad either.

I have the same wifi/bluetooth card as you. I still get good signal 30 feet away. TRy clearing your DNS caches Flushing DNS caches: 1. Open terminal and type sudo killall -HUP mDNSResponder and hit "enter" enter password if asked. 2. reboot

Ok guys if you gonna follow this install procedure, go download the new probook installer v5 http://www.tonymacx86.com/hp-probook/63348-hp-probook-installer-4-1b1.html probook v4 is old. Also if you build your unibeast with the new version 1.5.2, and delete your sleep image before you...

At 100% is 6800 mAH, sorry fail to mention I'm using the 9 cell battery.

Which USB kexts did you install?

I haven't notice any change on any of my probook, all three still getting over 4+ hrs with normal use. I was able to watch 3 full HD movies and still had about 15% left.

You were suppose to use your USB drive not your main HDD. It should be dd if=/Volumes/ML\ Install/usr/standalone/i386/boot1h of=/dev/disk0s2 And make sure you unmount your HDD first.

Disconnect AC adapter, remove battery, hold down power button for about 45 seconds. Plug AC adapter without battery install, see if it power on. If it don't try holding down power button longer.