Recent content by biographers25

hey all, I was finally able to get this build up and running. I attached the DSDT file that MiniITX so graciously made for me. The process was as follows: -install from Unibeast thumb drive -run Multibeast with the following settings (see attached screenshot) -use kextbeast to install the the...

ok, I'll rerun Multibeast with those settings. One thing I realized I wasn't sure about: when I'm doing these reboots should I be letting the system reboot from the USB ML or from the computer's ML? I've been using the USB ML. Maybe that is causing all these problems? D'oh.

I followed those instructions and somehow it's STILL not working. Getting stuck at the apple grey screen, frozen. rebooting now with verbose mode. EDIT: rebooting with verbose mode gets me stuck at the same point I was at earlier: sound assertion in AppleHDADriver at line 1052 By the way, I...

Booted into safe mode, downloaded that kext and moved it to the desktop, installed it via kext drop, rebooted. and still getting a frozen apple screen. I forgot to repair permissions!!! Now its not even letting me reboot into safe mode. :(

When I boot up with -v -x -F, it stops at ACPI_SMC_Platformplugin timed out. Gonna start over again and see if it helps to not have the partition (sadly).

My BIOS settings: running version f2 boot option #1 is set to UFEI Intel Virtualization Technology is disabled SATA mode selection: AHCI xHCI mode: disabled Internal graphics: enabled internal graphics memory size: 64m xHCI hand-off: enabled

Booting with GraphicsEnabler=No boot flag didn't work either.

Well, I followed the boot0 error guide, rebooted normally and got a frozen apple grey startup screen. I was asked to install the ethernet driver after I installed Multibeast. should I have not done that? I'm booting up now in verbose mode to see what the issue was. the last few lines are...

Got a boot0 error. Trying to resolve it now with the boot0 error guide.

Also, can I partition the HD before installing ML? I tried doing this before and it seemed to cause problems, though maybe those problems were caused by other things. I'd prefer to have a partition if possible, as it's a big drive (2 TB).

Cool, I'll do that now. Do I need to do either of these things: -before restarting, followed graphics resolution page tutorial -show all in finder, moved kexts to desktop, edited, ran kextbeast -reboot from USB drive "USB" as per boot0 error guide tutorial -unmounted ML drive, entered...

ML. Did that one not work either? Maybe I should try a different DSDT editor? I was using this one: http://olarila.com/forum/viewtopic.php?f=7&t=62

trying again. see if this one works. sorry about that.

the zip is attached! thanks!

No problem. I downloaded a DSDT editor, saved as a DSL. Where do I attach it? Do you mean it attach it here so you can look at it? I am trying to and the forum isn't letting me attach the file for some reason. Do I need to edit the DSDT file somehow? thanks again.