Recent content by Aup808

I think that's a fair point! And where I was leaning with initially - I just wasn't sure if individuals had different recommendations if they knew I might use the Windows partition slightly more often than the Mac, but I prefer the more stable build versus the non-supported/experimental. Thanks...

Thank you for the reply! For the WD SN750, do you go with the Gen3 or Gen4 model? I would definitely go that route if that is the preferred performance upgrade! And yeah, I have been shifting through that thread as well - I know for folks that use primarily the Mac partition, the Z490/LGA1200...

Hey everyone, I built my first Hackintosh quite a bit ago (and I'm still actively using it; Sandy Bridge i7-2700K and all), and I'm looking to get back into the game and build my second Hackintosh. After doing quite a bit of research on these threads, I think I have most of the compatible parts...

Hello, I set up my High Sierra today on my blank SSD. Before I begin, I will say I think the way I "cleared" out my SSD may be the cause, but essentially I used my Windows 10 boot disk / diskpart to "clean" the disk (I had to remove the Windows EFI that was there before that Disk Utility was...

Hey @Going Bald , thanks for the suggestion. I want to go for your suggestions of starting fresh; clean my two SSDs, and use my two install USBs (Win10 and High Sierra) to start from scratch, based on your guides. I deleted the Volume 3, as you suggested. I also went to clean Disk 0 (just so...

Or would the "safer" route be to take off all my partitions, reinstall Windows 10 on just the Windows SSD I have and force the EFI partition to be placed on the same volume? I would like to NOT do that (not trying to redo the installation work), but if that's the "easier"/better method to ensure...

@vulgo , here is my CMD command prompt. It says it created the boot for WIN10 BOOT, but when I click on it from the Clover bootloader, nothing happens. Is that because I need to delete the other "EFI" 200MB volume and delete the EFI folder from C:\Windows first?

Thanks for your reply @vulgo ; I read through your article and tried the "bcdboot C:\Windows /s B: /f UEFI", and while it said it was successful, it still didn't show up on the bootloader. Just last evening I attempted to upgrade my Yosemite/Chameleon to High Sierra/Clover (to take your advice...

As an update, I plugged into my Windows SSD and took a look at Disk Management. Disk 0 (My macOS SDD): Seems the 200MB EFI that I'm seeing is the Windows Boot EFI. Since the Mac Disk Utility didn't delete that, do I need to use diskpart on Windows to completely wipe that SSD and try to...

Hey everyone, Motherboard: Z68XP-UD4 (U1L BIOS, UEFI) CPU: Intel i7-2700k Graphics: GTX 1050 Ti SC In my current setup, I have two SSDs (one which has my macOS partition on it, and one that has my Windows partition), and a few HDDs (one is a shared "Data" drive where I keep all my documents...

Hey everyone, I've run into a bit of an issue, and I have read similar folks running into same issue but I think I am missing a crucial step to fix this and I cannot figure out where. :) I run Windows and Mac on two separate SSDs, and recently I upgraded my Windows 7 partition to Windows 10...

As an update, "nv_disable=1", "-x","-v", and "-f" don't work; "-x" leads to black screen before it reboots, and "-v" leads to the screenshot in my original post with no Mac loading screen. "nv_disable=1" leads to the Mac loading screen but it doesn't leave the halfway point. I can sort of log in...

Thanks @james-bond007 for the insight. I'll look into making a High Sierra installer; do you have any insight on how I'll be able to log into my Yosemite though in my current setup to create the USB installer?

Hey @james-bond007 ; yeah, my motherboard is U1L (UEFI BIOS). I didn't think High Sierra supported Sandy Bridge, but was I wrong on that assumption?

Hey everyone! I've been running my Hackintosh for a few years now (it was dual booting with Mountain Lion and Windows 7), and it has some older hardware: Motherboard: GA-Z68XP-UD4 CPU: Intel i7 2700K It was running on GTX 570 HD SC, which as of a few months ago died on me. EVGA was very kind...