This is why I am asking. As far as I can tell both methods accomplish the same thing: Let macOS load the SMU firmware to the GPU. The kernel panic seems to only happen when used with the Radeon framebuffer but not with names ones.
It is APFS which Trims the whole disk on mount and unmount. Trimforce is only for SATA disk AFAIK. Nvme has always trim.
That said, I only experience delays on boot (the boot just takes long while it's trimming) and shutdown also.
You experience hangs during normal operation?
How can all antennas be for BT? Bluetooth does not support any multi antenna techniques AFAIK.
I did some experimenting and could identify the left most output as the bluetooth (or 2,4GHZ in general) antenna. Removing this antenna was the only one that influenced the BT rssi. And it influenced...
I have the GC-TitanRidge on my Asrock board and it works fine with some minor nits under Windows and macOS with my LG Ultrafine. Gigabyte released a new firmware (B20.0320.1 from 2020/03/26) for the card and I tried to install it and was greeted with this error when starting the flash tool...
Yea I do not even bother to use sleep on my Hack. It's just to much hassle for me. It's a desktop anyways. It's not about sleep but just a "normal" reboot. But I guess it's the same cause. Firmware only properly initialized thunderbolt device on a cold start.
I recently bought a LG Ultrafine 5k Thunderbolt display. It is detected in Windows 10 and macOS. Everything is working fine so far. I do not intend to hotplug it. However, there are some minor grumbles which I think might be related to hotplugging and this SSDT.
I am using a Gigabyte Titan...