Recent content by anotherguyver

So far so good. I found the problem. Probably not a good idea to install the UEFI version of the bootloader on a non-UEFI-system. Anyhow, with the fresh install and MultiBeast almost everything is working perfectly. Graphics work OOB, Audio, Sleep. I just have a little problem with the network...

The system now boots with clover without any flags. However, I started getting the HPET kernel panic. HPET is on in the BIOS and set to 64bit. I also noticed, that there are no kexts in EFI/Clover/kexts/10.11 However, when the system was working the last time, all of the kexts were located...

Update for reference: I seem to have found the problem for the [PCI configuration begin] kernel panic. Although I assumed otherwise, the F4 BIOS Version of this MB does have an option for virtualisation. As soon as I turned that off, I could boot into the system just fine without any flags. The...

Hi Guys, I am trying to get El Capitan to work (system in signature). A few years ago I had successfully running 10.8 on this system without any problems. However, 10.11 seems to be a little more tricky. So here is all that I tried until now: I booted up with UniBeast with Clover and installed...

A little update: I've managed to get everything to run, except for a few things: 1.The sound works fine, but the channels are switched. R=L and L=R. I noticed, while using a headset. I installed the ALC8xxxHDA and the HDA Rollback. 2.I still can't get the onboard Graphics to work. Intel...

I followed your tutorial and it worked...somehow..I don't know. The card is being recognized, but the system says, that no kernel is loading. I did, in fact, get the chess to work for about 3 moves, then it crashed on me. After I got the grey screen, I deleted the EVO Enabler and booted after...

Hey Guys, having a few Problems here getting my Lion Installation to run. I also don't know whether this should go into the post-installation section, but since I would have to post into every single one of the subsections, I'd rather try it here. So this is how things are so far: System...

@sanguinarypc How did you get the GA-H67MA-D2H-B3 to work? I have the exactly same board and the exactly same CPU, but can't seem to get 10.7.2 to recognize any of the hardware. Did you install SL first? Thanks in advance. (And sorry for posting a direct question, but I can't send PMs yet).