Recent content by _thep0pe_

Thanks, don't know how I missed that. I'm ordering that now, as well as some ram upgrades. Meanwhile, I hope I can get wifi, sound, and sleep working.

Back story: I just did a fresh install of Catalina 10.15.5 with unibeast and multibeast. It went pretty smoothly and I was still trying to iron out issues with graphics, wifi card, and sleep. I was able to boot from the hard drive, run multibeast, and I selected the legacy clover boot mode...

Hi all, my probook 4530s is crashing after waking. I've read that memory might be corrupted after waking. Thoughts? When I turn it back on and look at the logs, I see this: Anonymous UUID: 8318ADE7-35EF-1446-02F6-783BED0340EA Wed Oct 18 09:05:33 2017 *** Panic Report *** panic(cpu 2...

interesting. i don't have the genericusb kext. This is the end of the road for my very limited understanding of this stuff. Initially I thought it might be a power supply problem or an oxidized wire or a short or something like that but everything like that is solid. Then I thought it may have...

Now, I sometimes get an error stating that usb is drawing too much power. Error message or not, my computer will crash 100% of the time if I unplug any usb device that wasn't plugged in at startup. I want to figure out how to patch usb power on DSDT. I tried turning legacy usb on and off at bios...

If the computer starts up with something in the front port, it's fine. If I unplug it, it's fine. Only if I plug in or remove something that wasn't plugged in at startup will it crash.

Is there a way to get front ports working or do I just have to buy a PCI usb hub?

If I insert or remove a usb cable/device in 10.9.2, it often causes a hard shutdown. When it does shut down, I see no crash report in the console. I don't know if this is kext related or.....?

My hack crashes whenever I plug in a usb cord to the front ports. I used to not get any error messages, but now I will sometimes get a "usb device drawing too much power" message. The message says it will only shut down the ports, but it's shutting down everything. I have a hard crash every...

@bigdonkey I have a probook 4530s with same webcam as you (same vendor/product id). I installed the kext you attached and my camera works for about 5-15 seconds before it stops. Do you have any ideas what might be causing it to freeze?

THANK YOU!!!!!!!!!!!! I tried EVERYTHING ELSE. I can't thank you enough. I looked all over, tried a lot of different methods. This was fast and easy.

so i bit the bullet and bought a LONG ethernet cable. deleted network devices in system preferences, deleted the networkinfaces.plist, reboot, et voila. problem solved. sigh.

using efi studio didn't work, deleting the networkinterfaces.plist didn't work, and flushing the cache didn't work either. any other suggestions?

bump I've been looking for this for a while. The most promising resource I found was from rehabman. https://github.com/RehabMan/HP-ProBook-4x30s-DSDT-Patch/wiki/How-to-patch-your-DSDT Not very useful instructions to me though, as I don't have much experience coding. I tried a couple of...