- Joined
- May 27, 2012
- Messages
- 759
- Motherboard
- DQ77KB
- CPU
- i7-3770S
- Graphics
- HD4000
- Mac
- Mobile Phone
The other important tool is fine tweezers (not pliers) for holding the wires. e.g.Ok. Going to try this before I spend any money.
http://m.instructables.com/id/Making-a-fine-tip-for-your-solding-iron-for-SMD-so/
Hopefully it'll work. I've got a decent mag glass.
Cheers!
http://www.digikey.com/product-detail/en/EROP7SA/EROP7SA-ND/114194
Then also fine solder, something around 0.5mm, basically as fine as you can get it.
For me the hardest part was stripping the insulation off the wires, it needs a very light touch with fine wire cutters then just pull off with finger nails to avoid damaging the wire.
Good luck