Dear Tony,
The Beast works, fine ! 2 question I have to ask :
1. Please give me some instruction about the right order of post installations. (Basics : 10.9.4 by unibeast 4.02, Unibeast 6.4, ga-z97x soc force , 4790k, Killer2200 LAN..., full clean installs)
Normally I do :
- Unibeast by the first boot. (start form the installation media and boot to the OSX hd)
************************************************** *****
Quick Start > DSDT Free
No Audio
Drivers > Disk > 3rd Party SATA
Drivers > Disk > TRIM Enabler > 10.9.4 TRIM Patch
Drivers > Misc > FakeSMC v6.8.1307
Drivers > Misc > FakeSMC v6.8.1307 Plugins
Drivers > Misc > FakeSMC v6.8.1307 HWMonitor Application
Drivers > Misc > USB 3.0 - Universal
Drivers > Network > Killer™ E2200 1.02
Drivers > System > AppleRTC Patch for CMOS Reset
Bootloaders > Chimera v3.0.1
Customize > Boot Options > Basic Boot Options
Customize > Boot Options > Hibernate Mode - Desktop
Customize > Boot Options > IGPEnabler=No
Customize > Boot Options > Use KernelCache
Customize > Boot Options > 1080p Display Mode
Customize > System Definitions > iMac > iMac 14,2
Customize > Themes > tonymacx86 Black
************************************************** *****
- Imessage fix in the 2nd boot with system UID and serial alignment.
- PM states fix in the 3rd with SSDT "tweak"
- Personalisation later on . . .
2. I've an issue with LAN (Killer™ E2200) : I lost my LAN connection after few boot finally. (Everything OK, but there is no data transfer on LAN) Somehow DCPIManager show the right LAN information, the system profiler also show every detail. The tricky point is : in System pref. (where also everything looks fine) I cannot edit the IPs, any other settings. I could wrote it in, but 1-2 seconds later the values I entered will go back to default (for example given numbers from DHCP)
I have no clue about the source of the problem probably PM related . . .
1. Do you agree the upper mentioned order of post installation?
2. Do you have any known issues about the mentioned LAN simptome?
THX !!