- Joined
- Mar 28, 2012
- Messages
- 28
- Mac
- Classic Mac
- Mobile Phone
Thanks.
I looked around on this site & found that most people solved their "boot1 : error" problem by using a different USB drive, so I did the same. I used a USB3 drive (I have 2 USB 3 ports on my Gigabyte Motherboard, so...) & it installed UniBeast in 11 minutes. 4 times faster than my other drive. I was able to boot to the USB drive, however when I chose the USB drive my screen went black & the monitor looks like it's in Power Saver Mode. The system is ON, but nothing appears to be happening. The USB flash drive isn't flashing. The HDD light is not flashing. Is that 'normal'?
I'll give it a few more minutes & try again.
Any help on this would be most appreciated. Thank you.
I looked around on this site & found that most people solved their "boot1 : error" problem by using a different USB drive, so I did the same. I used a USB3 drive (I have 2 USB 3 ports on my Gigabyte Motherboard, so...) & it installed UniBeast in 11 minutes. 4 times faster than my other drive. I was able to boot to the USB drive, however when I chose the USB drive my screen went black & the monitor looks like it's in Power Saver Mode. The system is ON, but nothing appears to be happening. The USB flash drive isn't flashing. The HDD light is not flashing. Is that 'normal'?
I'll give it a few more minutes & try again.
Any help on this would be most appreciated. Thank you.