Monterey/Ventura on HP EliteDesk 800 G4/G5 Mini - The Perfect MacMini8,1 Hackintosh - OpenCore

[logyon]

I went back through the bios which i have not been in since i set the mac up for catalina and at some point the usb back ports where disabled in the bios ?!?!

Thank you for fixing the usb and bluetooth. all working now.

 

[logyon]

anyone used sidecar on this device yet

 

[ranches101]

I'm getting a problem with deleting parition, my computer reboots.

It seems there is a problem with deletion of partion, I'm using nvme ssd as the install drive.

 

[UtterDisbelief]

I'm getting a problem with deleting parition, my computer reboots.

It seems there is a problem with deletion of partion, I'm using nvme ssd as the install drive.

Please complete your Hardware Profile - it is a part of the Site Rules and helps others to be able to help you.

You do have an HP EliteDesk 800 G4/G5 Mini?

 

[Bogito]

anyone used sidecar on this device yet

Missing FeatureUnlock.kext. Try this:

 

[taskrov]

Please delete post.

 

[jlsilvan2]

Occasionally, i found the solution.
We should complete the Graphic configuration in DeviceProperties of config.plist to figure out how many video ports are there on motherboard and which type are the ports, DP, HDMI or VGA.
If no configurations are there, macOS will fall into disorder about how to output video signal.
Problem was solved by referring to [GUIDE] General Framebuffer Patching Guide (HDMI Black Screen Problem) | tonymacx86.com.
Below is my configuration with 2*DP and 1*HDMI.
View attachment 545474
After adding these configurations, the monitor works well whenever it wakes up from sleeping or turns off and on the monitor.

Hello. Can you please share the EFI folder of your hackintosh?
Many Thanks

 

[taskrov]

I am trying to get wake up working. The system sleeps fine and wakes up but the screen is dark. When I power off/on the monitor the screen comes back. I followed the OC 0.8.6 Guide to install Ventura 13.0.1. I created my own SSDT's and USBMap.kext with latest recommended tools and the install went smoothly and everything else seems to be working. I read and re-read the Guide, the Whatevergreen FAQs and played around with Hackintool to create the DeviceProperty -> Add section, but no luck. The monitor is connected to the HDMI port and there are two DP ports. They all behave the same way. I have searched all over and there is a lot written about this issue but I cannot find a solution that works for me. I would highly appreciate some assistance. I have attached my sanitized EFI folder. Thank you.

Edit: It turned out that the problem was with the monitor I was using. Using a DP->DP connection with a 2K Lenovo monitor wake & sleep work as expected.

 

[logyon]

Upgraded to the 13.1 with no issues this afternoon

 

[fontanero]

Hi, my setup has two DP ports and one VGA.
Sometimes I see some flickering.
I have removed the VGA port and left only two DP ports.
What configuration should I put in OC config.plist?
I don't see only with two DP or the three DP?
Thank you very much.