Contribute
Register

Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

My BT400 arrived today. It appears in the USB list, but not in Bluetooth. And it fails to work.
I can understand the frustration. Why not use the Intel Bluetooth module that's preinstalled on the motherboard? Basic Bluetooth connection will work. Apple's Handoff/Continuity functions aren't supported.
 
My BT400 arrived today. It appears in the USB list, but not in Bluetooth. And it fails to work.

Where do you have it plugged in? Mine’s in the top left USB on the back panel ie one of the USB2 sockets.
 
Hmmm. It doesn't seem widespread so I wonder if it's a config issue, or has something to do with which USB port the card is plugged in to.

EDIT - Regarding Bluetooth magic mouse not reconnecting after wake. It's a major usage hindrance since I need to reboot to wake sometimes.
 
Last edited:
This just showed up on my Z490 Vision D hack. Should I reinstall 12.0.1? The OSX side of this Dual boot machine has been wildly unstable. OSX 12.0.1 freezes almost daily. The Windows 11 side runs like a champ w/ no issues. I'm convinced it's a software / config issue. I just update OpenCore to 0.7.6 and the only change I made to Casey's EFI was to remove boot argument agdpmod=pikera (for my Vega 64) and set AAPL,ig-platform-id to 0300C89B (for headless Comet Lake iGPU). Any advice would be appreciated I've been troubleshooting this build for a week and I'm stumped. My BIOS is exactly as specified by the guide, I'm on Firmware F5.
I had exactly same issues after installing BIOS F21b, flashed F20 and all gone.
 
Hi, thanks @CaseySJ another successfull update to OC 076:clap:
Quick question: should i enable ThirdPartyDrives Quirk for my old Samsung SATA SSD (used for some data only) or use trimforce enable command?
Note: My 2 "system" NVMe are PNY CS3030 (not Samsung) so they are fine with Trim i think.
 
Hi, thanks @CaseySJ another successfull update to OC 076:clap:
Quick question: should i enable ThirdPartyDrives Quirk for my old Samsung SATA SSD (used for some data only) or use trimforce enable command?
Note: My 2 "system" NVMe are PNY CS3030 (not Samsung) so they are fine with Trim i think.
Sure, feel free to try ThirdPartyDrives. It will enable trim automatically. Please refer to this post for more information:
 
I can understand the frustration. Why not use the Intel Bluetooth module that's preinstalled on the motherboard? Basic Bluetooth connection will work. Apple's Handoff/Continuity functions aren't supported.
Interestingly, the BT400 seems to be the same chip set as the built in. What steps are needed again to enable the built-in? Do I need a kext? At present you can't turn bluetooth on at all. I don't have the antennas installed at the moment.
 
Back
Top