Hi
@CaseySJ and everyone
First of all, thanks for this tremendous guide! It really is thoroughly written and easy to understand even for newbies like me.
Around July I bought this motherboard as well as the 5900x, rx6800xt, broadcom card, and bunch of hardware mentioned in the 1st page. I even bought the CH341a cause i want the full thunderbolt bus working. However, the website that I bought from didn't really update the naming of the board, and I only realize I got the D-P board after it arrived my place. I'm going to try the guide first, if it doesn't work I will have to switch to windows for the time being unfortunately.
My hardware list as below:
MB: B550 vision D-P
CPU: 5900x
Ram: ballistix DDR4-3600mhz 16GB x4
SSD: Aorus Gen4 7000s 1TB
GPU: 5700xt reference (I'm using this GPU from my previous z390 build to test it out first, since i know it works flawlessly)
because it is a D-P board, I would love to get a double confirm from you guys just so I didn't miss any of the steps.
I have been reading the post from page 90 sth and i know i need to update the config.plist and include the realtek kext into the EFI folder.
Since I'm going for a fresh install, I grabbed the 0.7.2 opencore folder, put in the lucy realtek kexts, enabled it from the 12-core config, and also copied the device properties from the 0.7.0 config from #946.
And since I'm going to use my old 5700xt to test out the system before i put in the 6800xt, I also enabled the 5700xt aml.
The config.plist is attached.
Also, should I be using the F2 BIOS or the newest F12 BIOS for the D-P board? I'm going to disable resize BAR anyway.
Thanks for the helps!