Contribute
Register

pastrychef's Asus ROG Strix Z370-G Gaming (WI-FI AC) build w/ i9-9900K + AMD 6600 XT

ok, something is weard. i updated the bootloader to 0.6.7, but hackintool says again im on 0.6.3..
i use ur EFI (EFI OpenCore 0.6.7 Z370G.zip) and hackintool says again im on 0.6.3..
maybe clear cmos?

PCIE: Broadcom BCM943602CS 802.11AC WiFi + Bluetooth 4.0 PC Desktop WLAN Card PCI E 1X

USB devices: USB Dock, Logitech unify adapter(Mx Master)
I reset NVRAM.
 
I didn't, should I? Where can I find the option?

Yes.

It should be on the right... Here's an image I found on the Internet...
Screen-Shot-2020-04-24-at-9.57.47-PM.png
 
I want to buy a monitor with Thunderbolt 3 - ProArt Display PA27AC.
I would like Thunderbolt 3 with all the goodies like Apple.
 
I want to buy a monitor with Thunderbolt 3 - ProArt Display PA27AC.
I would like Thunderbolt 3 with all the goodies like Apple.

I never got Thunderbolt to work on this motherboard but I didn't try too hard...

I suspect it may be possible if you connect a Titan Ridge card to PCI-e x4 slot that's from PCH. It won't work from CPU attached PCI-e lanes.

You will also need to flash the Titan Ridge card for it to work with Thunderbolt displays.
 
Last edited:
Is USBinjectAll.kext doesn't work anymore on OpenCore 0.6.7.? My PCIe Bluetooth doesn't work.
On OpenCore 0.6.3 with USBinjectAll works.

Edit: now I'm using usbports.kext. PICe Bluetooth works!
 
Last edited:
So....My OpenCore boots a lot slower than my Clover install did, any ideas?
 
Hello Pastrychef! long time no see, I was hoping this would be about updating my computer but unfortunately I got a surprise today. couldn’t boot up, and in verbose mode it ended after beginning coredump of kernel ( attach file ), and i have no idea what even went wrong.
 

Attachments

  • image.jpg
    image.jpg
    4.3 MB · Views: 44
Back
Top