*** Thunderbolt DROM Micro-Guide for Gigabyte GC-Titan Ridge V1.0 ***
Please do not quote this micro-guide in its entirety. Post a link instead.
Posted this in a different thread- realized a week later that I’d probably get a response if I actually quoted the procedure I’m stuck on. Hopefully
@CaseySJ or
@djlild7hina can chime in
Here's what else is happening.
- Before I flashed it, I always had to unplug / replug the card right after I powered it up for the card to work. That still applies, but now, I can't even see the BIOS or any of the verbose mode during boot (which I always leave on). In fact, the monitors shut off due to no signal, then pop on once MacOS is booted. I guess this is a side-effect of using the flashed BIOS and the MiniDisplayPort cables routing from the video card to the Titan Ridge (if I need the BIOS, I can plug an HDMI in directly- so that's not the end of the world).
- If I follow what’s quoted, I can't get anything to connect to my Titan Ridge in any capacity. (I'm sure it's related to setting it to PC00 as
@CaseySJ and I discussed previously in a different thread), but I'm wondering if I did the process wrong.
- In System Report on the Hackintosh, the speed shows as 20Gb/s x2. I'm assuming this is also normal?
- As stated at the beginning, hot plug is completely gone. Before the flash, if I unplugged/replugged everything came back normally. Now, I have to either plug in an HDMI or just hold the power button for 5 seconds .... then because of the connected Thunderbolt 3 dock not powering on boot (an issue I had when TB3 was fully functioning with the old firmware), I have to unplug the Thunderbolt 3 cable when I power up, wait a second or 2, then plug it in
Any advice would be great lol. As it stands now, I'm using the original AML files
@CaseySJ supplied me earlier in the other thread and it's running all my devices like it did, except now with Thunderbolt 3 showing up in the System Report & no hot-plug at all.... so I'm getting SOMEWHERE LOL