- Joined
- May 30, 2016
- Messages
- 980
- Motherboard
- Gigabyte Z490 Vision G
- CPU
- i9-10900K
- Graphics
- RX 5700 XT
- Mac
- Classic Mac
- Mobile Phone
@dgsga @faithie999 @canyondust @losinka @scottkendall *Party Noises*
[SUCCESS] Gigabyte Designare Z390 (Thunderbolt 3) + i7-9700K + AMD RX 580
Are you using KGP's Thunderbolt hot plug SSDT right now? If so, does hot plug work? Using KGPs SSDT on the X299 D-EX build I did recently resulted in no hotplug at all. If I try one of the newer SSDTs available with the proper DROM implemented it still resulted in no Hot Plug. Maybe I missed...www.tonymacx86.com
This is incredible! Good freaking work. I'm going to flash my OEM firmware back onto my card and give it a go, go!
@CaseySJ, as for the Force Power issue I still keep tbforcepower.efi active as a backup. It's comes in handy when experimenting the with fixing sleep as it gets rid of the need for the shutdown/unplug fiasco.
Perhaps thats enough to get it going on the z390? It might take a boot and reboot to get it going. Good luck and thanks for being so thorough. This community is at it's brightest over here.
We should also update the XHC on the SSDT for the single USB port. You can use mine as a reference from the repo.
heyya @NorthAmTransAm where does one fine Tbforcepower.efi? I need a force-power solution for my setup as well, I have to boot with a TB device plugged in for the tree to load.
Cheers!
EDIT: I couldn’t find it because I was spelling it wrong. I found it.
Last edited: