Contribute
Register

Gigabyte Z390M - Empty Clover

Status
Not open for further replies.
Joined
Jul 21, 2018
Messages
36
Motherboard
Gigabyte z390m
CPU
i5-9600K
Graphics
RX 580
Mobile Phone
  1. iOS
Hey guys.

I appreciate the Internet that there is a forum like this where you can share your thoughts and get new knowledge.

I bought a new motherboard - Gigabyte Z390M, CPU: i5-9600K, GPU: Sapphire RX 580 Nitro +, RAM: Ballistix 16GB - all from Buyer's Guide here.

I changed the bios following Z390M Gaming guide but I can't see options in Clover menu. There's nothing in there.

I created a bootable USB drive and install Clover in it. But I can get any options and I don't know if that's the problem with the USB drive and its installation or my BIOS settings.

Please share your thoughts. Thank you in advance
 
Did you follow this guide?.

 
Did you follow this guide?.


Thanks for the reply. I would like to do vanilla installation. But I cannot find BIOS settings tailored to my motherboard.
 
I’ll try to install it by following the unibeast. I m newbie with it. But i’ll try to do my best
 
The BIOS settings tailored to your motherboard are in the link I just sent you. If you're planning on a 'Vanilla' installation by not using Unibeast or Clover then you're on the wrong website.
 
Also check the Golden Builds Forum and look for builds that are similar to your own, you will find lots of good advice there.
 
The BIOS settings tailored to your motherboard are in the link I just sent you. If you're planning on a 'Vanilla' installation by not using Unibeast or Clover then you're on the wrong website.
Got it. Could you tell me what’s the best option between these two? I m more familiar with Clover
 
To create your Unibeast installer follow the guide in the link I sent you, make sure to read it all, especially the part about BIOS settings. Clover is post installation.
 
Also check the Golden Builds Forum and look for builds that are similar to your own, you will find lots of good advice there.
Thanks. I’ve reviewed builds with their similar GA Z390M Gaming, but I’ve selected all the same in my BIOS in met empty Clover. Maybe the case in the bootable USB. But I installed it using the command, the install Clover in it and restart my PC and selected the UEFI USB drive- nothing. I’ll try BIOS settings from the thread you shared,. Thanks a lot. I've build this PC mainly for my work and really want to instal macOS to it.
 
To create your Unibeast installer follow the guide in the link I sent you, make sure to read it all, especially the part about BIOS settings. Clover is post installation.
Got it. Will do. Thank you sir. I hope it will work and I’ll beg pardon with whole community for my foolishness
 
Status
Not open for further replies.
Back
Top