Step 1:
Open Clover Bootloader installer and continue with bootloader installation into the HDD/SSD that we installed macOS.
The procedures are exactly the same as on the Creating USB Installer, except that this time, instead of the USB Drive, we select the "macOS" HDD/SSD that we installed macOS. Also, copy drivers from the "drivers\UEFI" folder to the "drivers\UEFI" folder on the Hard drive.
Step 2:
Now we need to install all the needed kexts into the HDD/SSD where we installed macOS.
All kexts should be installed into /Library/Extensions. Easiest way to Install kexts is with HackinTool. (
Guide). Install all the kexts from the Library/Extensions folder I have attached.
Remove AppleIntelLpssI2C.kext and AppleIntelLpssI2CController.kext from /System/Library/Extentions or disable them with clover configurator and replace IOPlatformPluginFamily.kext(rebuild cache with hackintool)
Remove all kexts except for Lilu,VirtualSMC and WhateverGreen from your \EFI\CLOVER\kexts\Other
Reboot and press F4 and Fn+F4 at the bootloader. (This will generate you DSDT and SSDT files)
Boot into the system and copy the DSDT and SSDT-PNLF from my Clover folder to EFI\CLOVER\ACPI\patched. (You should ideally create these on your own)
That's it! Ideally, if you have the same config you should be done, but I would always recommend the Vanilla way and fix issues one by one. (I have made simple Guides for this attached in my folder).
Step 3:
Use Hackintool to fix hibernation and for USB port patching. (Guides in the folder)
Add DPI controls
here.