- Joined
- Mar 5, 2020
- Messages
- 3
- Motherboard
- I didn't read
- CPU
- the RULES
- Graphics
- X1600
Hi all,
I remember seeing a post with detailed photos etc on how to perform the flash using CH341a. I think this post has been replaced/deleted however I have soldering experience and can apply the 3v3 rework needed for correct voltage levels on CH341a.
Rework:
Jumper set to 3v3 mode.
Would it be possible to post this again ? While I feel confident at looking at the pin outs for the programmer / device, I think it would also be helpful to have images that confirm what I am doing as correct.
Most importantly I am looking for photos that show:
Wiring Setup : Clip connection to device - Back on TR AIC, to the headers, and on the programmer
flash rom is installed and ready to use. What commands did you use to perform reads / writes.
Thanks!!
As always I assume all risk!!
Thanks,
I remember seeing a post with detailed photos etc on how to perform the flash using CH341a. I think this post has been replaced/deleted however I have soldering experience and can apply the 3v3 rework needed for correct voltage levels on CH341a.
Rework:
OOPS [Chuck Nemeth]
OOPS Until I can figure out how to properly do the 301 redirect, you're looking for this page: * MODIFY CH341A
www.chucknemeth.com
Jumper set to 3v3 mode.
Would it be possible to post this again ? While I feel confident at looking at the pin outs for the programmer / device, I think it would also be helpful to have images that confirm what I am doing as correct.
Most importantly I am looking for photos that show:
Wiring Setup : Clip connection to device - Back on TR AIC, to the headers, and on the programmer
flash rom is installed and ready to use. What commands did you use to perform reads / writes.
Thanks!!
As always I assume all risk!!
Thanks,