Black screen while updating to 10.15.1 Catalina

[Gustavodrn]

Check your Clover EFI folder see if there is CSMdre.efi? driver in Drivers UEFI folder. remove it if its there.

I have this below there, but nothing about CSMdre.efi

VBoxHfs.efi
SMCHelper.efi
PartitionDxe.efi
OsxFatBinaryDrv.efi
OsxAptioFix3Drv.efi
FSInject.efi
EmuVariableUefi.efi
DataHubDxe.efi
AudioDxe.efi
ApfsDriverLoader.efi
apfs.efi

Should I remove any?

 

[Gigamaxx]

I have this below there, but nothing about CSMdre.efi

VBoxHfs.efi
SMCHelper.efi
PartitionDxe.efi
OsxFatBinaryDrv.efi
OsxAptioFix3Drv.efi
FSInject.efi
EmuVariableUefi.efi
DataHubDxe.efi
AudioDxe.efi
ApfsDriverLoader.efi
apfs.efi

Should I remove any?

apfsefi since you have the auto loader there already.

 

[Gustavodrn]

apfsefi since you have the auto loader there already.

Done, I'll monitor if it works and post here again.
Thanks one more time mate!

 

[Gustavodrn]

apfsefi since you have the auto loader there already.

Unfortunately still same problem, tried to turn on today and got no video at all, it doesn’t even show me the motherboard startup logo

 

[P1LGRIM]

tried to turn on today and got no video at all, it doesn’t even show me the motherboard startup logo

You might try a CMOS reset.

 

[Gustavodrn]

You might try a CMOS reset.

How can I do that?

 

[P1LGRIM]

How can I do that?

Read your motherboard manual for details.

Usually disconnect from the mains electricity supply.
Short two pins together.
Alternatively remove the CMOS battery for a few seconds then reinstall it.

Afterwards all BIOS settings should restore to defaults.
Select optimised defaults then make any necessary changes.

 

[Big-W]

If it doesn't work, try to copy them directly in /L/E (/Library/Extensions) folder on your hackintosh.

Do not copy files straight to /Library/Extensions, these must be installed using hackintool, kextbeast or a kext installer.
They can however move/copy to /Kexts/Other/

 

[Big-W]

A lot of people are experiencing difficulties with updating from Mojave to Catalina on this thread. Could I ask if you updated to latest Clover version before updating? If you haven't and are experiencing boot problems, it could be due to this problem. Check your folder structures are correct.

 

[Gustavodrn]

Read your motherboard manual for details.

Usually disconnect from the mains electricity supply.
Short two pins together.
Alternatively remove the CMOS battery for a few seconds then reinstall it.

Afterwards all BIOS settings should restore to defaults.
Select optimised defaults then make any necessary changes.

I've done it, still same problem. I can use the computer with a HDMI port through the motherboard, but once I try to use my RX580 it doesn't work. I've tried different cables and all, as I said before, sometimes it works, sometimes doesn't. Don't know what to do.