Contribute
Register

[Solved] JPG Quick Preview Not Working in Mojave

Status
Not open for further replies.
Yes, enable iGPU in BIOS fix that! :headbang:
Thanks
 
quick look preview not working in mojave
ga 390 m gaming
intel i5 9600 processor
rx 570 radeon graphics
 

Attachments

  • Screenshot 2020-01-09 at 2.09.20 PM.png
    Screenshot 2020-01-09 at 2.09.20 PM.png
    1.7 MB · Views: 151
Dunno if anyone is still following this... sowieso... I noticed Preview crashed after installing a MSI Radeon RX560. I tried for a while to find a solution but to no avail... Then I unplugged the TV from the video card. Pouf! Preview works now... As I read the problem is with RX560/580 cards, but maybe someone could use it as a good point of entry for debug... Maybe if the devs from WEG are keeping an eye on Tonymac...
 
I had the same problem on a GigaByte Series 8 board. The fastest solution is to use a Mac ID which has no internal graphics card (I have a Radeon 580 and disabled the IGD in BIOS). I used clover configurator, load the config.plist from the boot drive's EFI folder and set in SMBIOS the model to iMacPro1,1. After reboot everything worked.

Thanks mate, this worked perfectly for me too!
 
After messing around with the Integrated Graphics fix for most of the morning (with absolutely no luck), I stumbled upon the reason: The integrated graphics on Sandy Bridge (i7-2600k) processors is not supported under Mojave. The solution for me was in this thread:
This was trivial to do, and worked perfectly.
 
I had the same problem on a GigaByte Series 8 board. The fastest solution is to use a Mac ID which has no internal graphics card (I have a Radeon 580 and disabled the IGD in BIOS). I used clover configurator, load the config.plist from the boot drive's EFI folder and set in SMBIOS the model to iMacPro1,1. After reboot everything worked.
Yes indeed, two years later and this still works well!
 
Status
Not open for further replies.
Back
Top