Contribute
Register

Broadcom WiFi/Bluetooth [Guide]

Thank you very much!

So interestingly, after I put the file you provided to the patched folder, restarted, found out that all ports are still showed, same as the stage while doing port discovery. Am I doing it incorrectly?

While preparing for port discovery, I did usbinjectall and XHCI unsupported to my clover/kext folder, and added these arguments to kext to patch:

View attachment 442616

and this is an screen shot of current io reg
View attachment 442617

this is my clover/kext/other folder look like:
View attachment 442618
Did I do anything wrong? Do you have a solution to this?

Just in case, I will also attach the Acpi clover configurator for an idea:
View attachment 442619

Thanks in advance.

Remove or disable the KextsToPatch.
 
Remove or disable the KextsToPatch.
Thanks for the reply.

I tried and here is the outcome,
The SSDT is not shown correctly...I don't know why
1577703597413.png
 
this is my efi file folder

What kind of Wi-Fi/Bluetooth card are you using?

Nevermind... I see you have DW1820A...

Please try with this EFI.
 

Attachments

  • EFI.zip
    24.6 MB · Views: 115
Last edited:
What kind of Wi-Fi/Bluetooth card are you using?

Nevermind... I see you have DW1820A...

Please try with this EFI.
Thank you so much. Now I see the port shows hs14 for bluetooth. Wondering would you mind sharing what did you do to make the port available? In addition, do I configure this efi to have my usb3.0 bus port discovered and configure the current patch?
 
Thank you so much. Now I see the port shows hs14 for bluetooth. Wondering would you mind sharing what did you do to make the port available? In addition, do I configure this efi to have my usb3.0 bus port discovered and configure the current patch?
usb setup guide:
 
Thank you so much. Now I see the port shows hs14 for bluetooth. Wondering would you mind sharing what did you do to make the port available? In addition, do I configure this efi to have my usb3.0 bus port discovered and configure the current patch?

You were using iMac19,2 system definition with a version of USBInjectAll that had no support for iMac19,2 system definition.

I thought that you had your USB ports configured already... If not, then follow the guide linked by Feartech.
 
usb setup guide:
Thanks. I was able to proceed after reconfiguring the SSDT.
 
You were using iMac19,2 system definition with a version of USBInjectAll that had no support for iMac19,2 system definition.

I thought that you had your USB ports configured already... If not, then follow the guide linked by Feartech.
Thank you pastrychef,
After following the SSDT guide, now I have a fully functioning bluetooth and I can do airdrop with it. Thanks for the help, happy holidays!
 
Back
Top