- Joined
- Feb 1, 2011
- Messages
- 36
I'm using a 1 x 16gb stickWhat RAM are you using and in what configuration is it in? I had the same issue using 64GB of RAM (2x32GB) and I was able to get past this error by only using 1x32GB in the 1st slot.
I'm using a 1 x 16gb stickWhat RAM are you using and in what configuration is it in? I had the same issue using 64GB of RAM (2x32GB) and I was able to get past this error by only using 1x32GB in the 1st slot.
Have you tried put the RAM stick in the other RAM slot?I'm using a 1 x 16gb stick
This working like a charm! Thank you all.Usually caused by the wrong (or missing) memory fix driver in /EFI/CLOVER/drivers64UEFI/.
why do these get erased when updating clover?
@GATEW4Y, I think you had the issue you did because none of the NUCs, 7s or 8s, max out at 32 MB Ram. Figures with 64MB it wouldn't boot
Updated to 10.14.4 success. We’re good!This working like a charm! Thank you all.
Booted from USB
Mounted EDI
Installed missing drivers (why do these get erased when updating clover?)
Rebooted into 10.14.3 just fine....
Now to try 10.14.4 update. Stay tuned!
I think you lucked out with Windows, from Intels specifications they say these babies max out at 32 MB RAM. If it runs great, if not it was never supposed to by design. Check for yourself on their website, attached is a scene shot from your NUC7 but its the same for 7s and 8s.Does anyone know for certain that it is not possible to run macOS on the NUC7 or NUC8 with 64GB RAM (2x32GB 2666 Samsung DDR4 RAM)? I have been able to get my NUC7 to run Windows 10 with 64GB RAM working perfectly.
Hi, I think that using 2666Mhz DDR4 RAM could be the issue : I use 2400Mhz sticks on a NUC8 box. G.G.Does anyone know for certain that it is not possible to run macOS on the NUC7 or NUC8 with 64GB RAM (2x32GB 2666 Samsung DDR4 RAM)? I have been able to get my NUC7 to run Windows 10 with 64GB RAM working perfectly.
Did you make sure to select the UEFI boot selections shown in the attached when installing? You can always run install again but double check the correct drivers and Kexts are still installed in your hard drive based EFI folder.I updated to latest stable Clover and left Mac OS alone. When I select Mac OS at reboot, the screen clears and nothing happens. The same behavior if I try to boot Mac OS install from the USB drive just to see if I can get anything to work. Windows 10 boots without issues (of course). Any ideas?