This is why I strongly advise against using any adapters during the test/setup procedure because it leads to a lot of confusing information in the IOReg file.But... the only port that works is the one with the dp to hdmi adapter, while the direct hdmi port doesn't work (really confused...)
With "apples" to "apples" cables, please try the config.plist files again and capture the IORegistryExplorer file with each one. This file contains important information about av-signal-type and connector-type that can be used to determine the correct patch configuration. Feel free to post your results and the IOReg files.Making some tests I think I understood the problem.
The second monitor has no hdmi but dvi input, and is connected to the system with a dvi to hdmi adapter and then connected to the hdmi port of the motherboard, the third monitor has instead only VGA output where a VGA to HDMi adapter is placed and is connected to the card with a DVI to HDMI adapter.
Tomorrow I buy direct cables and try everything again. Thank you very much for helping me, and sorry for the time I made you lose. Thank you!
The only other thing I can think of is the Clover version running on the Mojave SSD. You may want to try using the same version that was running under 10.14.3 or updating to the latest...
It would be best to start a new thread in the Mojave Desktop Support forum where other Asus owners may be able to help. You should of course describe the problem, the steps taken so far, the partial results (20 successful hours with HFS+), the version of Mojave, the make/model of the NVMe drive, any USB or PCIe devices in the system, etc.
It would be best to start a new thread in the Mojave Desktop Support forum where other Asus owners may be able to help. You should of course describe the problem, the steps taken so far, the partial results (20 successful hours with HFS+), the version of Mojave, the make/model of the NVMe drive, any USB or PCIe devices in the system, etc.
Just replied to your thread in Post Installation —> General Help.Nono now it has become a reboot and it only happens when I watch videos. For now 4k videos. When watching, after a while the PC freezes and after a few seconds reboots.