- Joined
- Jul 7, 2010
- Messages
- 353
- Motherboard
- Gigabyte GA-Z390 Gaming X
- CPU
- i9-9900
- Graphics
- HD 5870
- Mac
- Mobile Phone
Great, thank you very much! I will give this a try later this week.
Is your SSD plugged in internally or via USB? USB will not work for the installation of 10.14.No idea WTH is going on now. I made a Mojave installer USB stick (8 GB) and I get "Error Loading Operating System" in post. Nothing is plugged in except the USB stick and the new 1 TB SSD.
It's on the SATA bus. I think I discovered the problem - it was MBR instead of GUID partition table. Rebuilding the installer now.Is your SSD plugged in internally or via USB? USB will not work for the installation of 10.14.
Ugh. This is terrible. I did a clean install, got BT and WiFi working, then did Migration Assistant to move my applications over to the new Mojave SSD. Now, when I reboot, the progress bar gets about halfway then the screen goes black and appears to be off. Same in safe mode, too. Verbose goes by too fast for me to see what the heck is going on.
Hey,I think 0x3E920000 is meant for mobile computers (i.e. laptops). One connector is listed as LVDS.
https://www.tonymacx86.com/threads/guide-intel-framebuffer-patching-using-whatevergreen.256490/
I've been using 3E9B0007 (three DP connectors) for a while and it seems to work fine. Not sure what the benefits are though, as everything was working fine with Whatevergreen installed even before patching.
One thing I have not been able to resolve is getting a Hack to recognize monitors that weren't present at boot. Has any of you had more luck in this respect?
@AppleiPad556: You are my man! After endless tests I got my new system running on Mojave 10.14.1 with your EFI!
Don't know exactly what went wrong before but
In the end I got graphic acceleration working with you EFI.
- first I received a lot frozen bootscreens not starting Mojave at all
- then I managed to get the system working but then I encountered graphic glitches due to missing graphic acceleration (only 7MB of graphic ram)
Not working
Note
- Audio: No Audio device is available, is yours working?
- Bluetooth: Just learned BT only works with some BT Dongle, do you use BT?
For some test I updated to Whatsevergreen 1.2.5. and again boots screen will freeze. With 1.2.4, everything works fine.
Bluetooth: I don't think you have to have a dongle, at least I'm not using one. If you look at OP's first post, Erik used a Broadcom BCM94352Z (which is what I'm using). He swapped out the Intel Wifi chip (which is actually much easier to remove than expected) with the Broadcom chip. You then need a few kexts (I followed these instructions: https://www.tonymacx86.com/threads/broadcom-wifi-bluetooth-guide.242423/) and it should work.