Contribute
Register

[SUCCESS] Gigabyte Designare Z390 (Thunderbolt 3) + i7-9700K + AMD RX 580

During Stage 1 install when you ran Disk Utilities to format the hard drive, do you remember choosing “Show All Devices” and then selecting the parent name of your hard drive? And formatting it as MacOS Extended (Journaled)?

I wonder if adding the SAT0 to SATA patch in ACPI might help as well. This is available from the Clover Configurator ACPI screen, from the pop-up menu. I just stepped away from the house for a few hours but please try this as well.

Also, what happens if you ignore the error, power down the system completely, pull the power cable from the power supply for 10 seconds, then boot up again and try stage 2?

I tried that one sir. After rebooting I saw this recovery icon and immediately went to stage 2 installation but it says installer resources were not found. I’ll try working out the step you told sir and will get back to u. Thank u sir
 
Sir successfully booted into Mac :headbang: am so happy sir. After struggling for 3 long days and now it’s working. Thanks to you sir. Forever in your debt . After installing SAT0 to SATA patch. It worked sir.
 

Attachments

  • F272AAE4-8F80-46FB-9C81-FC9A10BBE2A0.jpeg
    F272AAE4-8F80-46FB-9C81-FC9A10BBE2A0.jpeg
    2.7 MB · Views: 268
In my case the SAT0 to SATA patch doesn't help.
 
help me please...

i work for 4days .... be tired

-----------------------------------
same MB,
RX970
LG 4K monitor ( connect DP cable )
samsung ssd 250G (SATA)
usb keyboard
usb mouse
-----------------------------------


#######
i want EFI(config.plist, Kext , etc...) for first install USB... because unibeast -> boot fail
#######
help me please...
 
help me please...

i work for 4days .... be tired

-----------------------------------
same MB,
RX970
LG 4K monitor ( connect DP cable )
samsung ssd 250G (SATA)
usb keyboard
usb mouse
-----------------------------------


#######
i want EFI(config.plist, Kext , etc...) for first install USB... because unibeast -> boot fail
#######
help me please...
If UniBeast —> Boot fail, please see if this helps (post #2).

Also update your profile: motherboard, cpu and graphics card information is required.
 
Back
Top