Contribute
Register

[Solved] Stop signal after boot

Status
Not open for further replies.
Joined
Dec 11, 2017
Messages
23
Motherboard
ASROCK Z370 EXTREME 4
CPU
I7 8700K
Graphics
GTX 1080
Mac
  1. MacBook Pro
Mobile Phone
  1. Android
Hi guys, I'm trying to install mojave on my pc with:
8700k
asrock z370 extreme 4
16gb ram corsair vengeance led 3000
Psu EVGA supernova g3 650w
dissi Deepcool ex240
Vga Zotac 1080 amp extreme
ssd crucial mx500 250gb

I followed the whole guide here on the forum but when I select the disk where to install mojave, the apple appears and then this symbol ... what should I do?
 

Attachments

  • photo_2018-11-19_18-48-07.jpg
    photo_2018-11-19_18-48-07.jpg
    24.5 KB · Views: 120
i've tried with verboso mode and this is result
 

Attachments

  • photo_2018-11-19_19-34-06.jpg
    photo_2018-11-19_19-34-06.jpg
    157.8 KB · Views: 146
  • photo_2018-11-19_19-57-04.jpg
    photo_2018-11-19_19-57-04.jpg
    156.3 KB · Views: 148
please, anyone can help me??
 
i've tried with verboso mode and this is result
"Still waiting for root device".
When installing this means that your USB flash drive cannot be found.
This is usually because the flash drive is in a USB3 port.
If this is the case move it to a USB2 port, if it is already in a USB2 port move it to another and try again.
Repeat until you have tried all USB ports.
Use a USB2 flash drive.
If it still doesn't work you could try another flash drive.
You might also try enabling Legacy on your USB3 ports in your BIOS settings.
If you only have USB3 ports try with your USB flash drive in a USB2 hub.
Make sure Fast Boot is not activated in your BIOS.

May require USBInjectAll.kext in /EFI/CLOVER/kexts/Other/.
May require XHCI-unsupported.kext in EFI/CLOVER/kexts/Other/.
 
"Still waiting for root device".
When installing this means that your USB flash drive cannot be found.
This is usually because the flash drive is in a USB3 port.
If this is the case move it to a USB2 port, if it is already in a USB2 port move it to another and try again.
Repeat until you have tried all USB ports.
Use a USB2 flash drive.
If it still doesn't work you could try another flash drive.
You might also try enabling Legacy on your USB3 ports in your BIOS settings.
If you only have USB3 ports try with your USB flash drive in a USB2 hub.
Make sure Fast Boot is not activated in your BIOS.

May require USBInjectAll.kext in /EFI/CLOVER/kexts/Other/.
May require XHCI-unsupported.kext in EFI/CLOVER/kexts/Other/.

thank you man!
I solved by creating a stick with clover and putting it on a USB 2.0 port
 
Status
Not open for further replies.
Back
Top