Contribute
Register

MultiBeast v11.0 for Mojave Not Out > What to Use?

Status
Not open for further replies.
Joined
Jul 17, 2016
Messages
22
Motherboard
Gigabyte Aorus MASTER Z390
CPU
i9-9900K
Graphics
Radeon VII
Mac
  1. iMac
Note: MultiBeast 11 will be ready soon- for now use MultiBeast 10.4.0 for Post-Installation
Do this mean that it is not possible to boot without USB key for now?
 
no, use Multibeast 10.4.0
Thanks. Tomorrow I’ll investigate about it.
I was able to install and boot using usb key,but I cannot boot from hd.
Good nigth
 
Thanks. Tomorrow I’ll investigate about it.
I was able to install and boot using usb key,but I cannot boot from hd.
Good nigth
Installation completed and HD bootable.
Now I only have to let my USB 3 webcam (Logitech Brio) work: is the code for config.plist available?
 
I am waiting for a fresh install with unibeast and multibeast made for mojave ! I don't want to make another install when multibeast 11 comes out !
Did you read posts 1-4 above ?
 
Installation completed and HD bootable.
Now I only have to let my USB 3 webcam (Logitech Brio) work: is the code for config.plist available?
Have you fully reinstalled system on hd??

I have same problem, can boot only via my usb key, tried to use multibeast 10.4.0 several times...using system already for month, really dont wont to pass via full installation process again))
 
Have you fully reinstalled system on hd??
I have same problem, can boot only via my usb key, tried to use multibeast 10.4.0 several times...using system already for month, really dont wont to pass via full installation process again))
Hello, I reinstalled the system several times deleting every time the whole hd, and finally everything worked (after about 3 evenings of work).
I phisically disconnected the second non-bootable sata ntfs hd ,leaving the system with only moJave hd. Then I create a single Mojave partition (earlier I tried creating a second partition for data), installed using English language and finally I tried using different Unibeast options. I added third party sata support, and if I remember right, intel generic AHCI driver (plus audio and network drivers). I have a radeon 580 graphics card, so I didn't need to add video drivers.
After successful boot, I connected again the second ntfs hd and resized Mojave partition, creating a second one.
Good luck.
 
To everyone in this thread, you do realize MultiBeast or Unibeast is not needed at all in order to make your USB Installer or install the EFI you use for your system to your HDD correct? Use Clover and Clover configurator that is all that is needed.
 
Status
Not open for further replies.
Back
Top