HP EliteDesk 800 G2 / HP ProDesk 600 G2 - SUCCESS

[PaintArm2]

https://www.tonymacx86.com/threads/hp-elitedesk-800-g2-hp-prodesk-600-g2-success.261452

Thanks in Advance....

thank me if it works.....

 

[arehep]

https://www.tonymacx86.com/threads/hp-elitedesk-800-g2-hp-prodesk-600-g2-success.261452



Paintarm2 its a really bad idea to use same Serial Number,Board Serial Number and SmUUID on different machines.
So Edelton use that info from your own config.plist
Copy paste to config.plist from Paintarm2
Otherwise you might run into trouble if you use iMessage,Facetime and iCloud

 

[PaintArm2]

I change it before I uploaded the folder incase Edelton didn't change it himself

 

[edelton]

thank me if it works.....

Thanks so much it works but boots only with ig-platform 193B0005 and I just don't know why IT WONT boot with ig-platform 1912000 .... now I have Native audio through Displayport.... Is there a way to get the Audio Jacks working too?

 

[PaintArm2]

Glad that worked for you. I’m not sure about the ig-platform issue.

I’m currently looking at getting the jacks working too at the moment. More research is needed

 

[PaintArm2]

IT WONT boot with ig-platform 1912000

Are you adding the ig-platform manually when clover loads like in your guide? It’s set in the config so you shouldn’t need to. Also it may be a typo but you are missing a 0 on the one quoted. Should be 0x19120000

 

[pastrychef]

Try this one, guys.

Be sure to make a backup of your existing/working EFI in case something goes horribly wrong.

 

[PaintArm2]

Try this one, guys.

Be sure to make a backup of your existing/working EFI in case something goes horribly wrong.

ok, I tried your EFI and it has certainly enabled the rest of the audio jacks. cheers pastry chef

I had to make some changes as 2 of my USB ports were blocked and the graphics were flickery but all good now

Only issue I have (which I had before) is my USB 3 ports don't register any devices unless I slowly pull them back out a bit. I'll look into that tomorrow I think

 

[pastrychef]

ok, I tried your EFI and it has certainly enabled the rest of the audio jacks. cheers pastry chef

I had to make some changes as 2 of my USB ports were blocked and the graphics were flickery but all good now

Only issue I have (which I had before) is my USB 3 ports don't register any devices unless I slowly pull them back out a bit. I'll look into that tomorrow I think

Oops. I configured the USB for a ProDesk 600 G2. You can change this in config.plist > Boot > Custom Flags. Delete the "uia_exclude=" stuff. Then add the 15 port limit patch to KextsToPatch.

Edit:
Try this one. I made the fixes.

 

[PaintArm2]

I’ve already sorted it I believe but will try that one tomorrow when I get a chance. Thanks