Contribute
Register

[EMERGENCY] After updating clover (with the configurator) and updating the APFS.efi i cannot boot

Status
Not open for further replies.
Install Clover onto a USB flash drive.
Put apfs.efi into /EFI/CLOVER/drivers64UEFI/ on the EFI partition.
Boot from the USB and at the boot loader screen select your hard drive and boot.

i can access the UEFI partition of the high sierra hard drive from this yosemite one with clover configurator.
I just want to know if i can use the apfs file from tonymacx86
 
i can access the UEFI partition of the high sierra hard drive from this yosemite one with clover configurator.
I just want to know if i can use the apfs file from tonymacx86
You can use any apfs.efi.
 
You can use any apfs.efi.

Done, nothing changed
That said i really think it's a clover problem, as this happened after i updated clover with the configurator.
Clover also has some problems booting this other drive (for which i had to use it's original old bootloader).
Is there any settings you suggest me to check? i can check the high sierra config.plist with the configurator from this yosemite hard drive
 
Done, nothing changed
That said i really think it's a clover problem, as this happened after i updated clover with the configurator.
Clover also has some problems booting this other drive (for which i had to use it's original old bootloader).
Is there any settings you suggest me to check? i can check the high sierra config.plist with the configurator from this yosemite hard drive
Install the previous clover version.
 
How can i do that, if i can't access the high sierra drive?
Clover is not on the High Sierra partition - It is on the EFI partition - You can access that.
 
Status
Not open for further replies.
Back
Top