10.13.5 High Sierra

[esen112]

Hi I am trying to create a hackintosh on the 10.13.5 update using UniBeast 8.1.0

My build is in the profile description, I followed the steps at this link:
https://www.tonymacx86.com/threads/...ierra-on-any-supported-intel-based-pc.235474/

I am stuck on STEP 4

The problem is this: when I try to boot off the USB (I am using a USB 2.0 port for the flash drive but also tried usb 3.0)



Here are the UniBeast settings I used to create the drive:




The result with the post-install folder:



The BIOS settings I used:
1) BOOT priority: WDC WD10EZEX (1 TB HDD) > UEFI: KingstonDataTraveler 2.0 (Fast Boot: Disabled)
2) CPU config:

Intel Virtualization Technology: Disabled
Hyper-threading: Enabled
Active Cores: All
Intel Adaptive thermal monitor: Enabled
Limit CPUID max: Disabled
Execute Disable bit: Enabled

CPU power management config:

CPU ratio: Auto, Enhanced Intel SpeedStep Technology and Turbo Mode are: Enabled
CPU C1E, C3 report, C6 report, Package C state support are all on: Auto​

3) PCH config is on default
4) SATA config

SATA mode selection: AHCI
SMART status check: Enabled

Hot Plugs are Disabled​

5) System Agent config is on default
6) USB config

Legacy USB support: Enabled
Legacy USB 3.0 support: Enabled (also tried disabled)
Intel xHCI Mode: Enabled
EHCI Hand-off: Disabled
KingstonDataTraveler 2.0: Auto (but I tried both forced FDD and hard disk settings)​

7) Serial Port: Disabled
8) Restore AC power Loss: Power Off
9) Network Stack: Disabled

I'm kinda new to this whole Hackintosh thing, but I wanna get this working I am really motivated,

Thanks for reading and give suggestions on what I can do,

Esen

 

[P1LGRIM]

Why are you using Clover r4297 ? That is probably too old.

 

[esen112]

Why are you using Clover r4297 ? That is probably too old.

I tried downloading and installing the latest clover version from Sourceforge, but it seems incompatible with High Sierra 10.13.5 which I am running on my Macbook Air. The install fails due to not being "optimized" for MacOS

​

​

 

[P1LGRIM]

I tried downloading and installing the latest clover version from Sourceforge, but it seems incompatible with High Sierra 10.13.5 which I am running on my Macbook Air. The install fails due to not being "optimized" for MacOS

It doesn't have to be the latest but it probably needs to be newer than r4297.
Clover Builds

 

[esen112]

It doesn't have to be the latest but it probably needs to be newer than r4297.
Clover Builds

It doesn't have to be the latest but it probably needs to be newer than r4297.
Clover Builds

How do I do that? UniBeast comes with r4297

 

[PaintArm2]

What unibeast version are you using?