Architecture Couldn’t Be Recognized (PMC_BOOT_42 = 0x00000013)

[Nyak]

I’m doing a fresh install on new NAND M.2 drive, running on the Rehabman branch of Clover v2.4k r4444 due to a previous kernel cache error I just resolved. Another post indicated disabling SATA in the peripherals tab of my BIOS would solve the problem, but it just resulted in a different cause for the same error, which is shown below. Any ideas?

 

[P1LGRIM]

Try this :

 

[Nyak]

Try this :

No luck sadly. Tried both with and without SATA enabled. Does the IOGraphics flag indicate a graphics problem? Should I try install with the card out or with nv_disable=1?

 

[P1LGRIM]

Serial ports (SuperIO) should be disabled in your BIOS settings.

 

[Nyak]

Serial ports (SuperIO) should be disabled in your BIOS settings.

View attachment 334905

Disabled what I think is serial port and the errors leading up to “architecture couldn’t be recognized” change. I couldn’t find SuperIO in the ROG BIOS, I think the setting is under Onboard Devices Configuration>Serial Port Configuration. Here’s an updated screenshot.

 

[zilvinomeile]

Disabled what I think is serial port and the errors leading up to “architecture couldn’t be recognized” change.

Did you overcome this situation? I'm having the same 'architecture couldn’t be recognized' problem while trying to install High Sierra.

Thank you.

 

[Chuls]

Did you overcome this situation? I'm having the same 'architecture couldn’t be recognized' problem while trying to install High Sierra.

Thank you.

Have you found a solution? I am currently experiencing the same issue with OpenCore.
Thanks in advance