RehabMan
Moderator
- Joined
- May 2, 2012
- Messages
- 181,058
- Motherboard
- Intel DH67BL
- CPU
- i7-2600K
- Graphics
- HD 3000
- Mac
- Mobile Phone
Hi @RehabMan, I desperately need your help in determining if there are errors in my SSDT-UIAC.aml creation. I have followed this guide as best as I could, but there seem to be problems - my USB3 (Sabrent UIN3) card reader, connected to a USB3 header on the motherboard, is recognised and powered up (and works flawlessly) when I boot using the SSDT-UIAC, but it disappears after the first sleep/wake, and then the computer cannot go into proper sleep (it sleeps, and then the fans spin up again and the screen comes back on, again and again, in an endless loop). I am afraid I might have made a mistake marking/not marking a USB2/USB3 or an internal hub as something else.
Also, if I don't boot from scratch (turn the power switch off on the SMPS/power supply, and then back on), the card reader does not get powered on and/or detected. Can't figure out why. Beyond my knowledge and understanding.
Could you please go through my files. I have supplied all problem reporting files, along with other files that I think might help.
The card reader works flawlessly on a linux boot (on a separate hard drive) on the same computer, which leads me to believe that the problem lies somewhere with how I have done my ACPI implementation and/or SSDT creation.
Your help is greatly appreciated.
Attach ioreg from after sleep/wake.
Note: Since SS01 is connected to an internal device, it should be marked UsbConnector=255 (you have 3).