- Joined
- Feb 3, 2014
- Messages
- 100
- Motherboard
- Gigabyte Z390 Designare
- CPU
- i9-9900K
- Graphics
- GTX 780 Ti
Here are the specs of my system:
Motherboard: Gigabyte GA-Z87N-WIFI
CPU: Intel i7 4770k
GPU: Internal HD4600
RAM: Hyper X Fury DDR3 2x4GB 1600MHz
SSD: Crucial MX100 512GB
Here's what I did:
- F12 Boot From Unibeast USB High Sierra
- Choose USB Installer
- Reboot and F12 Boot from Unibeast USB again
- Choose disk image installer
- Reboot and F12 Boot from Unibeast USB
- Multibeast with Clover UEFI + FakeSMC + NullCPUManagement + USB Drivers for 7/8/9 series MB
- Installation Confirmation and Reboot
- Error messages during startup
If I choose the safe mode during startup, I get a MACH REBOOT error message. If I choose the normal startup, I get an ACPI table error.
I've attached my whole EFI drive (disk0s1) from my SSD in ZIP format.
Is the EFI folder at least correct? What about config.plist?
Motherboard: Gigabyte GA-Z87N-WIFI
CPU: Intel i7 4770k
GPU: Internal HD4600
RAM: Hyper X Fury DDR3 2x4GB 1600MHz
SSD: Crucial MX100 512GB
Here's what I did:
- F12 Boot From Unibeast USB High Sierra
- Choose USB Installer
- Reboot and F12 Boot from Unibeast USB again
- Choose disk image installer
- Reboot and F12 Boot from Unibeast USB
- Multibeast with Clover UEFI + FakeSMC + NullCPUManagement + USB Drivers for 7/8/9 series MB
- Installation Confirmation and Reboot
- Error messages during startup
If I choose the safe mode during startup, I get a MACH REBOOT error message. If I choose the normal startup, I get an ACPI table error.
I've attached my whole EFI drive (disk0s1) from my SSD in ZIP format.
Is the EFI folder at least correct? What about config.plist?