System Report showing only USB 3.0

[KungFuJoe]

Is this normal? All my USB ports seem to work, even the 2.0 ones. I get USB 3 speeds as well. Normally, I would just chalk it off as a cosmetic issue and call it a day, but I'm having a weird issue with my Iogear USB bluetooth controller. When I have it plugged in and synced with my keyboard/mouse...it works great. Even as far as going to sleep and waking from either the BT mouse or keyboard.

Except for one thing. Every once in a while (usually once a day), the system will not wake up and will be frozen (can't ping it, so network is off). I have to hard reset the system and when it comes back up, I have to pull out and reinsert the bluetooth USB module to see the kb/mouse again. Then it works fine for an entire day or so until it happens again.

Also, there was a single incident of my system hard locking when I inserted a SD card (using a USB adapter)...system completely froze up and I had to hard reset. I was using the Iogear module at the time.

I have since been using only USB mouse/kb (removed the Iogear adapter) for the last 2 days and have not had any incidents.

I'm running High Sierra and using onboard HD 530 graphics (need to update my profile). I'm using the 3rd Party USB 3.0 (GenericUSBXHCI.kext) and Increase Max Port Limit 100 Series options from MultiBeast.

Am I missing anything?

 

[RehabMan]

Is this normal?

Yes.
0xa12f is the xHCI controller on 100-series.
100-series boards have no EHCI controller only xHCI, therefore you should expect only "USB 3.0 Bus"

See here for correct USB configuration:
https://www.tonymacx86.com/threads/guide-creating-a-custom-ssdt-for-usbinjectall-kext.211311/

 

[KungFuJoe]

Yes.
0xa12f is the xHCI controller on 100-series.
100-series boards have no EHCI controller only xHCI, therefore you should expect only "USB 3.0 Bus"

See here for correct USB configuration:
https://www.tonymacx86.com/threads/guide-creating-a-custom-ssdt-for-usbinjectall-kext.211311/

I was able to configure a custom SSDT for my USB ports using the link you posted and it appears to be working. Hope that fixes my USB lock up issues...but if they reoccur I will start a new thread.

Thanks!