OS X 10.11.6 Update

[MacSimizeDenver]

No support for Enoch here, sorry.

Nah, come on. Really? What kind of thing or private war is this? Not really friendly nor helpful, to be honest. At least you could say where else I should turn to. Because as you may read I had no chance to use Clover at all.

 

[Feartech]

Nah, come on. Really? What kind of thing or private war is this? Not really friendly nor helpful, to be honest. At least you could say where else I should turn to. Because as you may read I had no chance to use Clover at all.

How do you expect to get support for software that isn't used here?

 

[P1LGRIM]

Nah, come on. Really? What kind of thing or private war is this? Not really friendly nor helpful, to be honest. At least you could say where else I should turn to. Because as you may read I had no chance to use Clover at all.

Any posts referencing unapproved installation software, methods, or websites will be deleted. Approved installation methods are as follows: iBoot, UniBeast or Clover

 

[AlphaFox]

Nah, come on. Really? What kind of thing or private war is this? Not really friendly nor helpful, to be honest. At least you could say where else I should turn to. Because as you may read I had no chance to use Clover at all.

Everyone here uses clover, I'm sure someone could help you with it. It should be able to work with any configuration. a lot of the posters in here don't speak good English and can post things that seem rude but they aren't intended that way.

 

[bel3atar]

is it possible to create a bootable USB of 10.11.6 instead of just 10.11?

 

[nimernimer]

what makes you think its not possible

 

[mrmacdi]

Just installed 2017-001 security update on my 10.11.6, it successfully booted once, then i've changed IONetwork kext to make my Yukon LAN work again (do it after each update), replaced IOUSBHostFamily to make second USB work, system has showed a message that kexts were installed incorrectly, so I ran Kext Utility, restarted and KP on each boot :/

P.S. After update my _external_ usb card has started to work really bad: sound distortions for system effects, playback hangs after a few seconds, then resumes - before update it was OK out-of-the-box.

 

[imaj]

I upgraded to 10.11.6 and am now getting the "Entering Power Save Mode" at the progress bar on startup...then screen goes black! Anyone know what I did wrong? Thank you!

 

[BreBo]

I upgraded to 10.11.6 and am now getting the "Entering Power Save Mode" at the progress bar on startup...then screen goes black! Anyone know what I did wrong?

If you use the Nvidia Web Drivers you need to update them
If you use the MacPro 6,1 or iMac 15 or iMac 17 System Definition you may need to re-apply the AGDPfix

 

[imaj]

Since I did not do a backup! ERR!!! Is there a way I can get into my system to install? Thank you!