@Xavi16
I have some good news!
Have you changed your EFI Post Install Files?
I copied them twice before into the EFI partition and I could never boot. I downloaded them again today and copied once more to see if I could make it work. I copied the HackrNVMeFamily. kext into the kext directory.
The clover boot screen came up and I started to boot. The boot screen progress went to 1/3 like before but now instead of a reboot, the screen went black and the progress like reappeared without the apple logo and it finished booting. The problem was that I had lost all of my USB ports and I could not move the mouse or key my password.
I booted off of the USB after several attempts and added the X99USBControllers.kext to my kext directory and tried to reboot again.
This time the clover boot screen came up in black and white with only the clover moving in blue. It was a different boot screen but I booted again and saw that the progress line under the apple went to 1/3 and then the screen went black again and only the line appeared and went to the end and I booted into OS X with USB functionality again.
I logged in and the screen did not flicker like before. I looked at the system configuration and I now have Apple Audio, it correctly recognizes my GT 730, and I have information under my PCI section. It seems stable and I think it is running well.
You have put a lot of effort into this guide and I am sorry that I have taken so much of your time but even though I made many mistakes, I would never have this running without you and your guide.
I do not know why it boots black and white like it does, but it does not really make a difference.
I am now going to go to your Final adjustments section to try and enable the iCloud.
I was looking at this yesterday and I do not think I was doing it correctly. I went to everyman.com like you said in the guide but it seems that it wants a serial number. My serial number is blank. Your guide says to generate a serial number. Do you do that in the Rt Variables tab where it says "Calculate"?
Also, when I save the file do I just save the file or do I need to "Generate Config"?
Thanks